-This sets the vertical size of the current staff to 4 staff spaces on
-either side of the center staff line. The argument of
-@code{minimumVerticalExtent} is interpreted as an interval, where the
-center line is the 0, so the first number is generally negative. The
-staff can be made larger at the bottom by setting it to @code{(-6
-. 4)}.
-
-The piano staves are handled a little differently: to make cross-staff
-beaming work correctly, it is necessary that the distance between staves
-is fixed beforehand. This is also done with a
-@internalsref{VerticalAlignment} object, created in
-@internalsref{PianoStaff}. In this object the distance between the
-staves is fixed by setting @code{forced-distance}. If you want to
-override this, use a @code{\translator} block as follows:
-@example
- \paper @{
- \translator @{
- \PianoStaffContext
- \override VerticalAlignment #'forced-distance = #9
- @}
- @dots{}
- @}
-@end example
-This would bring the staves together at a distance of 9 staff spaces,
-measured from the center line of each staff.
-
-@seealso
-
-Internals: Vertical alignment of staves is handled by the
-@internalsref{VerticalAlignment} object.
-
-
-
-
-@node Horizontal spacing
-@subsection Horizontal Spacing
-
-The spacing engine translates differences in durations into
-stretchable distances (``springs'') of differing lengths. Longer
-durations get more space, shorter durations get less. The shortest
-durations get a fixed amount of space (which is controlled by
-@code{shortest-duration-space} in the @internalsref{SpacingSpanner} object).
-The longer the duration, the more space it gets: doubling a
-duration adds a fixed amount (this amount is controlled by
-@code{spacing-increment}) of space to the note.
-
-For example, the following piece contains lots of half, quarter and
-8th notes, the eighth note is followed by 1 note head width (NHW).
-The quarter note is followed by 2 NHW, the half by 3 NHW, etc.
-@lilypond[fragment,verbatim,relative=1] c2 c4. c8 c4. c8 c4. c8 c8
-c8 c4 c4 c4
-@end lilypond
-
-Normally, @code{shortest-duration-space} is set to 1.2, which is the
-width of a note head, and @code{shortest-duration-space} is set to
-2.0, meaning that the shortest note gets 2 NHW (i.e. 2 times
-@code{shortest-duration-space}) of space. For normal notes, this space
-is always counted from the left edge of the symbol, so the shortest
-notes are generally followed by one NHW of space.
-
-If one would follow the above procedure exactly, then adding a single
-32th note to a score that uses 8th and 16th notes, would widen up the
-entire score a lot. The shortest note is no longer a 16th, but a 32nd,
-thus adding 1 NHW to every note. To prevent this, the
-shortest duration for spacing is not the shortest note in the score,
-but the most commonly found shortest note. Notes that are even
-shorter this are followed by a space that is proportional to their
-duration relative to the common shortest note. So if we were to add
-only a few 16th notes to the example above, they would be followed by
-half a NHW:
-
-@lilypond[fragment,verbatim,relative=2]
- c2 c4. c8 c4. c16[ c] c4. c8 c8 c8 c4 c4 c4
-@end lilypond
-
-The most common shortest duration is determined as follows: in every
-measure, the shortest duration is determined. The most common short
-duration, is taken as the basis for the spacing, with the stipulation
-that this shortest duration should always be equal to or shorter than
-1/8th note. The shortest duration is printed when you run lilypond
-with @code{--verbose}. These durations may also be customized. If you
-set the @code{common-shortest-duration} in
-@internalsref{SpacingSpanner}, then this sets the base duration for
-spacing. The maximum duration for this base (normally 1/8th), is set
-through @code{base-shortest-duration}.
-
-@cindex @code{common-shortest-duration}
-@cindex @code{base-shortest-duration}
-@cindex @code{stem-spacing-correction}
-@cindex @code{spacing}
-
-In the introduction it was explained that stem directions influence
-spacing. This is controlled with @code{stem-spacing-correction}
-property in @internalsref{NoteSpacing}, which are generated for every
-@internalsref{Voice} context. The @code{StaffSpacing} object
-(generated at @internalsref{Staff} context) contains the same property
-for controlling the stem/bar line spacing. The following example
-shows these corrections, once with default settings, and once with
-exaggerated corrections:
-
-@lilypond
- \score { \notes {
- c'4 e''4 e'4 b'4 |
- b'4 e''4 b'4 e''4|
- \override Staff.NoteSpacing #'stem-spacing-correction
- = #1.5
- \override Staff.StaffSpacing #'stem-spacing-correction
- = #1.5
- c'4 e''4 e'4 b'4 |
- b'4 e''4 b'4 e''4|
- }
- \paper { raggedright = ##t } }
-@end lilypond
-
-@cindex SpacingSpanner, overriding properties
-
-Properties of the @internalsref{SpacingSpanner} must be overridden
-from the @code{\paper} block, since the @internalsref{SpacingSpanner} is
-created before any property commands are interpreted.
-@example
-\paper @{ \translator @{
- \ScoreContext
- SpacingSpanner \override #'spacing-increment = #3.0
-@} @}
-@end example
-
-
-@seealso
-
-Internals: @internalsref{SpacingSpanner}, @internalsref{NoteSpacing},
-@internalsref{StaffSpacing}, @internalsref{SeparationItem}, and
-@internalsref{SeparatingGroupSpanner}.
-
-@refbugs
-
-Spacing is determined on a score wide basis. If you have a score that
-changes its character (measured in durations) halfway during the
-score, the part containing the longer durations will be spaced too
-widely.
-
-There is no convenient mechanism to manually override spacing.
-
-
-
-@node Font Size
-@subsection Font size
-@cindex font size, setting
-@cindex staff size, setting
-@cindex @code{paper} file
-
-The Feta font provides musical symbols at eight seven different
-sizes. Each font is tuned for a different staff size: at smaller sizes
-the font gets heavier, to match the relatively heavier staff lines.
-The recommended font sizes are listed in the following table:
-
-@multitable @columnfractions .25 .25 .25 .25