-Line breaks are normally determined automatically. They are chosen
-so that lines look neither cramped nor loose, and consecutive
-lines have similar density. Occasionally you might want to
-override the automatic breaks; you can do this by specifying
-@code{\break}. This will force a line break at this point. However,
-line breaks can only occur at the end of @q{complete} bars, i.e.,
-where there are no notes or tuplets left @q{hanging} over the bar
-line. If you want to have a line break where there is no bar line,
-you can force an invisible bar line by entering @code{\bar ""},
-although again there must be no notes left hanging over in any of
-the staves at this point, or it will be ignored.
-
-The opposite command, @code{\noBreak}, forbids a line break at the
-bar line where it is inserted.
+Line breaks are normally determined automatically. They are
+chosen so that lines look neither cramped nor loose, and
+consecutive lines have similar density.
+
+To manually force a line break at a bar line, use the
+@code{\break} command:
+
+@lilypond[quote,ragged-right,relative=2,verbatim]
+c4 c c c | \break
+c4 c c c |
+@end lilypond
+
+By default, a @code{\break} in the middle of a measure is ignored,
+and a warning is printed. To force a line break in the middle of
+a measure, add an invisible bar line with @w{@samp{\bar ""}}:
+
+@lilypond[quote,ragged-right,relative=2,verbatim]
+c4 c c
+\bar "" \break
+c |
+c4 c c c |
+@end lilypond
+
+A @code{\break} occurring at a bar line is also ignored if the
+previous measure ends in the middle of a note, such as when a
+tuplet begins and ends in different measures. To allow
+@code{\break} commands to work in these situations, remove the
+@code{Forbid_line_break_engraver} from the @code{Voice} context.
+Note that manually forced line breaks have to be added in parallel
+with the music:
+
+@lilypond[quote,ragged-right,verbatim]
+\new Voice \with {
+ \remove "Forbid_line_break_engraver"
+} \relative c'' {
+ <<
+ { c2. \tuplet 3/2 { c4 c c } c2. | }
+ { s1 | \break s1 | }
+ >>
+}
+@end lilypond
+
+Similarly, line breaks are normally forbidden when beams cross bar
+lines. This behavior can be changed by setting
+@code{\override Beam.breakable = ##t}:
+
+@lilypond[quote,ragged-right,relative=2,verbatim]
+\override Beam.breakable = ##t
+c2. c8[ c | \break
+c8 c] c2. |
+@end lilypond
+
+The @code{\noBreak} command forbids a line break at the bar line
+where it is inserted.
+
+Within a score, automatic line breaking is prevented within music
+lying between @code{\autoLineBreaksOff} and @code{\autoLineBreaksOn}
+commands. If automatic page breaks should also be prevented, the
+commands @code{\autoBreaksOff} and @code{\autoBreaksOn} should be
+used. Manual breaks are unaffected by these commands. Note that
+inhibiting automatic line breaks may cause music to run over the
+right margin if it cannot all be contained within one line.
+
+Automatic line breaks (but not page breaks) may be enabled at single
+bar lines by using @code{\once \autoLineBreaksOn} at a bar line.
+This identifies a permitted rather than a forced line break.