Keyboard: Migrate Quefrency to use split common files (#3642)

[qmk_firmware.git] / keyboards / quefrency / rules.mk

diff --git a/keyboards/quefrency/rules.mk b/keyboards/quefrency/rules.mk
index 93ccd2b05521a40409f2729f421127bd08c92124..b78dc5df7b64771ff5fc1ac3e4f7e571f2aeace3 100644 (file)
--- a/keyboards/quefrency/rules.mk
+++ b/keyboards/quefrency/rules.mk
@@ -1,48 +1,7 @@
-SRC += matrix.c \
-          i2c.c \
-          split_util.c \
-          serial.c
-
-# MCU name
-#MCU = at90usb1287
 MCU = atmega32u4
-
-# Processor frequency.
-#     This will define a symbol, F_CPU, in all source code files equal to the
-#     processor frequency in Hz. You can then use this symbol in your source code to
-#     calculate timings. Do NOT tack on a 'UL' at the end, this will be done
-#     automatically to create a 32-bit value in your source code.
-#
-#     This will be an integer division of F_USB below, as it is sourced by
-#     F_USB after it has run through any CPU prescalers. Note that this value
-#     does not *change* the processor frequency - it should merely be updated to
-#     reflect the processor speed set externally so that the code can use accurate
-#     software delays.
 F_CPU = 16000000
-
-#
-# LUFA specific
-#
-# Target architecture (see library "Board Types" documentation).
 ARCH = AVR8
-
-# Input clock frequency.
-#     This will define a symbol, F_USB, in all source code files equal to the
-#     input clock frequency (before any prescaling is performed) in Hz. This value may
-#     differ from F_CPU if prescaling is used on the latter, and is required as the
-#     raw input clock is fed directly to the PLL sections of the AVR for high speed
-#     clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
-#     at the end, this will be done automatically to create a 32-bit value in your
-#     source code.
-#
-#     If no clock division is performed on the input clock inside the AVR (via the
-#     CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
 F_USB = $(F_CPU)
-
-# Bootloader
-#     This definition is optional, and if your keyboard supports multiple bootloaders of
-#     different sizes, comment this out, and the correct address will be loaded
-#     automatically (+60). See bootloader.mk for all options.
 BOOTLOADER = caterina
 
 # Interrupt driven control endpoint task(+60)
@@ -69,6 +28,6 @@ USE_I2C = yes
 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
 SLEEP_LED_ENABLE = no    # Breathing sleep LED during USB suspend
 
-CUSTOM_MATRIX = yes
+SPLIT_KEYBOARD = yes
 
 DEFAULT_FOLDER = quefrency/rev1