A two-switch tester built using two Pro Micros, mainly intended to test RGB on split keyboards. Seen here: https://www.instagram.com/p/BvCPNzynwrV/
Keyboard Maintainer: [Bakingpy/nooges](https://github.com/nooges)
-Hardware Supported: Pro Micro
+Hardware Supported: Pro Micro, Teensy 2.0
+Hardware Availability:
+
+**See each individual board for pin infomation**
Make example for this keyboard (after setting up your build environment):
make handwired/splittest:default:avrdude
See the [build environment setup](https://docs.qmk.fm/#/getting_started_build_tools) and the [make instructions](https://docs.qmk.fm/#/getting_started_make_guide) for more information. Brand new to QMK? Start with our [Complete Newbs Guide](https://docs.qmk.fm/#/newbs).
-
-Wiring
-------
-- Add switches to both Pro Micros across B3 and B6 pins
-- Add pull-up resistor to left side between VCC and F6
-- Add pull-down resistors to right side between GND and F6
-- Connect the following pins on both sides together: D0, D1, GND, VCC
-- Add I2C 4.7kOhm resistors between D0 and VCC, and D1 and VCC
-- Wire Di of RGB strip for each half to D2