6 # This will define a symbol, F_CPU, in all source code files equal to the
7 # processor frequency in Hz. You can then use this symbol in your source code to
8 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
9 # automatically to create a 32-bit value in your source code.
11 # This will be an integer division of F_USB below, as it is sourced by
12 # F_USB after it has run through any CPU prescalers. Note that this value
13 # does not *change* the processor frequency - it should merely be updated to
14 # reflect the processor speed set externally so that the code can use accurate
21 # Target architecture (see library "Board Types" documentation).
24 # Input clock frequency.
25 # This will define a symbol, F_USB, in all source code files equal to the
26 # input clock frequency (before any prescaling is performed) in Hz. This value may
27 # differ from F_CPU if prescaling is used on the latter, and is required as the
28 # raw input clock is fed directly to the PLL sections of the AVR for high speed
29 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
30 # at the end, this will be done automatically to create a 32-bit value in your
33 # If no clock division is performed on the input clock inside the AVR (via the
34 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
37 # Interrupt driven control endpoint task(+60)
38 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
41 # change to "no" to disable the options, or define them in the Makefile in
42 # the appropriate keymap folder that will get included automatically
44 BOOTMAGIC_ENABLE = no # Virtual DIP switch configuration(+1000)
45 MOUSEKEY_ENABLE = no # Mouse keys(+4700)
46 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
47 CONSOLE_ENABLE = yes # Console for debug(+400)
48 COMMAND_ENABLE = no # Commands for debug and configuration
49 NKRO_ENABLE = no # Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
50 BACKLIGHT_ENABLE = no # Enable keyboard backlight functionality
51 MIDI_ENABLE = no # MIDI controls
52 AUDIO_ENABLE = yes # Audio output on port C6
53 UNICODE_ENABLE = no # Unicode
54 BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID
55 RGBLIGHT_ENABLE = no # Enable WS2812 RGB underlight.
58 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
59 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
61 LAYOUTS = ortho_4x12 planck_mit planck_grid
63 DEFAULT_FOLDER = planck/rev5