void usb_device_reload()
{
- if ( flashModeEnabled_define == 0 )
- {
- print( NL );
- warn_print("flashModeEnabled not set, cancelling firmware reload...");
- info_msg("Set flashModeEnabled to 1 in your kll configuration.");
- return;
- }
-
// MCHCK
-#if defined(_mk20dx128vlf5_)
-
- // MCHCK Kiibohd Variant
- // Check to see if PTA3 (has a pull-up) is connected to GND (usually via jumper)
- // Only allow reload if the jumper is present (security)
- GPIOA_PDDR &= ~(1<<3); // Input
- PORTA_PCR3 = PORT_PCR_PFE | PORT_PCR_MUX(1); // Internal pull-up
-
- // Check for jumper
- if ( GPIOA_PDIR & (1<<3) && flashModeEnabled_define != 0 )
- {
- print( NL );
- warn_print("Security jumper not present, cancelling firmware reload...");
- info_msg("Replace jumper on middle 2 pins, or manually press the firmware reload button.");
- }
- else
- {
- // Copies variable into the VBAT register, must be identical to the variable in the bootloader to jump to the bootloader flash mode
- for ( int pos = 0; pos < sizeof(sys_reset_to_loader_magic); pos++ )
- (&VBAT)[ pos ] = sys_reset_to_loader_magic[ pos ];
- SOFTWARE_RESET();
- }
-
// Kiibohd mk20dx256vlh7
-#elif defined(_mk20dx256vlh7_)
+#if defined(_mk20dx128vlf5_) || defined(_mk20dx256vlh7_)
// Copies variable into the VBAT register, must be identical to the variable in the bootloader to jump to the bootloader flash mode
for ( int pos = 0; pos < sizeof(sys_reset_to_loader_magic); pos++ )
(&VBAT)[ pos ] = sys_reset_to_loader_magic[ pos ];