Cleans up quantum/keymap situation, removes extra lufa folders (#416)

[qmk_firmware.git] / tmk_core / tool / mbed / mbed-sdk / libraries / mbed / common / board.c

diff --git a/tmk_core/tool/mbed/mbed-sdk/libraries/mbed/common/board.c b/tmk_core/tool/mbed/mbed-sdk/libraries/mbed/common/board.c
deleted file mode 100644 (file)
index 9103236..0000000
--- a/tmk_core/tool/mbed/mbed-sdk/libraries/mbed/common/board.c
+++ /dev/null
@@ -1,59 +0,0 @@
-/* mbed Microcontroller Library
- * Copyright (c) 2006-2013 ARM Limited
- *
- * Licensed under the Apache License, Version 2.0 (the "License");
- * you may not use this file except in compliance with the License.
- * You may obtain a copy of the License at
- *
- *     http://www.apache.org/licenses/LICENSE-2.0
- *
- * Unless required by applicable law or agreed to in writing, software
- * distributed under the License is distributed on an "AS IS" BASIS,
- * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
- * See the License for the specific language governing permissions and
- * limitations under the License.
- */
-#include "gpio_api.h"
-#include "wait_api.h"
-#include "toolchain.h"
-#include "mbed_interface.h"
-
-WEAK void mbed_die(void) {
-#ifndef NRF51_H
-       __disable_irq();        // dont allow interrupts to disturb the flash pattern
-#endif
-#if   (DEVICE_ERROR_RED == 1)
-    gpio_t led_red; gpio_init_out(&led_red, LED_RED);
-#elif (DEVICE_ERROR_PATTERN == 1)
-    gpio_t led_1; gpio_init_out(&led_1, LED1);
-    gpio_t led_2; gpio_init_out(&led_2, LED2);
-    gpio_t led_3; gpio_init_out(&led_3, LED3);
-    gpio_t led_4; gpio_init_out(&led_4, LED4);
-#endif
-
-    while (1) {
-#if   (DEVICE_ERROR_RED == 1)
-        gpio_write(&led_red, 1);
-
-#elif (DEVICE_ERROR_PATTERN == 1)
-        gpio_write(&led_1, 1);
-        gpio_write(&led_2, 0);
-        gpio_write(&led_3, 0);
-        gpio_write(&led_4, 1);
-#endif
-
-        wait_ms(150);
-
-#if   (DEVICE_ERROR_RED == 1)
-        gpio_write(&led_red, 0);
-
-#elif (DEVICE_ERROR_PATTERN == 1)
-        gpio_write(&led_1, 0);
-        gpio_write(&led_2, 1);
-        gpio_write(&led_3, 1);
-        gpio_write(&led_4, 0);
-#endif
-
-        wait_ms(150);
-    }
-}