Add 16U2, 16U4 and USB646 to mcu_selection.mk (#6566)

[qmk_firmware.git] / keyboards / sixkeyboard / rules.mk

diff --git a/keyboards/sixkeyboard/rules.mk b/keyboards/sixkeyboard/rules.mk
index 6aedc714857dab0c5265a3802a05222b3fd3a379..b718c7e65fba761fea27d7b54bba3fd9e787a727 100644 (file)
--- a/keyboards/sixkeyboard/rules.mk
+++ b/keyboards/sixkeyboard/rules.mk
@@ -1,47 +1,8 @@
-
-
 SRC = matrix.c
 
 # MCU name
-#MCU = at90usb1287
 MCU = atmega16u2
 
-# Processor frequency.
-#     This will define a symbol, F_CPU, in all source code files equal to the
-#     processor frequency in Hz. You can then use this symbol in your source code to
-#     calculate timings. Do NOT tack on a 'UL' at the end, this will be done
-#     automatically to create a 32-bit value in your source code.
-#
-#     This will be an integer division of F_USB below, as it is sourced by
-#     F_USB after it has run through any CPU prescalers. Note that this value
-#     does not *change* the processor frequency - it should merely be updated to
-#     reflect the processor speed set externally so that the code can use accurate
-#     software delays.
-F_CPU = 16000000
-
-
-#
-# LUFA specific
-#
-# Target architecture (see library "Board Types" documentation).
-ARCH = AVR8
-
-# Input clock frequency.
-#     This will define a symbol, F_USB, in all source code files equal to the
-#     input clock frequency (before any prescaling is performed) in Hz. This value may
-#     differ from F_CPU if prescaling is used on the latter, and is required as the
-#     raw input clock is fed directly to the PLL sections of the AVR for high speed
-#     clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
-#     at the end, this will be done automatically to create a 32-bit value in your
-#     source code.
-#
-#     If no clock division is performed on the input clock inside the AVR (via the
-#     CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
-F_USB = $(F_CPU)
-
-# Interrupt driven control endpoint task(+60)
-OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
-
 
 # Boot Section Size in *bytes*
 #   Teensy halfKay   512
@@ -67,4 +28,4 @@ MIDI_ENABLE = no                      # MIDI controls
 AUDIO_ENABLE = no
 UNICODE_ENABLE = no            # Unicode
 BLUETOOTH_ENABLE = no  # Enable Bluetooth with the Adafruit EZ-Key HID
-CUSTOM_MATRIX = yes
\ No newline at end of file
+CUSTOM_MATRIX = yes