Adds basic support for u/flehrad's bigswitch pcb (#3015)

[qmk_firmware.git] / keyboards / bigswitch / rules.mk

diff --git a/keyboards/bigswitch/rules.mk b/keyboards/bigswitch/rules.mk
new file mode 100755 (executable)
index 0000000..e4e72f0
--- /dev/null
+++ b/keyboards/bigswitch/rules.mk
@@ -0,0 +1,60 @@
+# MCU name
+MCU = atmega32u4
+
+# Processor frequency.
+#     This will define a symbol, F_CPU, in all source code files equal to the
+#     processor frequency in Hz. You can then use this symbol in your source code to
+#     calculate timings. Do NOT tack on a 'UL' at the end, this will be done
+#     automatically to create a 32-bit value in your source code.
+#
+#     This will be an integer division of F_USB below, as it is sourced by
+#     F_USB after it has run through any CPU prescalers. Note that this value
+#     does not *change* the processor frequency - it should merely be updated to
+#     reflect the processor speed set externally so that the code can use accurate
+#     software delays.
+F_CPU = 16000000
+
+#
+# LUFA specific
+#
+# Target architecture (see library "Board Types" documentation).
+ARCH = AVR8
+
+# Input clock frequency.
+#     This will define a symbol, F_USB, in all source code files equal to the
+#     input clock frequency (before any prescaling is performed) in Hz. This value may
+#     differ from F_CPU if prescaling is used on the latter, and is required as the
+#     raw input clock is fed directly to the PLL sections of the AVR for high speed
+#     clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
+#     at the end, this will be done automatically to create a 32-bit value in your
+#     source code.
+#
+#     If no clock division is performed on the input clock inside the AVR (via the
+#     CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
+F_USB = $(F_CPU)
+
+# Bootloader
+BOOTLOADER = caterina
+
+# Interrupt driven control endpoint task(+60)
+OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
+
+
+# Boot Section Size in *bytes*
+OPT_DEFS += -DBOOTLOADER_SIZE=4096
+
+
+# Build Options
+#   comment out to disable the options.
+#
+BOOTMAGIC_ENABLE  = no # Virtual DIP switch configuration(+1000)
+MOUSEKEY_ENABLE  = no  # Mouse keys(+4700)
+EXTRAKEY_ENABLE  = no  # Audio control and System control(+450)
+CONSOLE_ENABLE  = yes  # Console for debug(+400)
+COMMAND_ENABLE  = yes    # Commands for debug and configuration
+SLEEP_LED_ENABLE  = no  # Breathing sleep LED during USB suspend
+NKRO_ENABLE  = no              # USB Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
+BACKLIGHT_ENABLE  = no  # Custom backlighting code is used, so this should not be enabled
+AUDIO_ENABLE  = no # This can be enabled if a speaker is connected to the expansion port. Not compatible with RGBLIGHT below
+RGBLIGHT_ENABLE  = yes # This can be enabled if a ws2812 strip is connected to the expansion port.
+