adds backlight levels to the satan keyboard (#431)

[qmk_firmware.git] / keyboard / planck / planck.c

diff --git a/keyboard/planck/planck.c b/keyboard/planck/planck.c
index da7b3a1702b6f2fddd8ac9b5dd3edb32ff8141db..f1a76266ecd1241071523f98d033112d12feb5c7 100644 (file)
--- a/keyboard/planck/planck.c
+++ b/keyboard/planck/planck.c
@@ -19,10 +19,6 @@ void matrix_init_kb(void) {
        backlight_init_ports();
 #endif
 
-#ifdef RGBLIGHT_ENABLE
-       rgblight_init();
-#endif
-
        // Turn status LED on
        DDRE |= (1<<6);
        PORTE |= (1<<6);
@@ -61,20 +57,20 @@ void backlight_init_ports()
     // Setup PB7 as output and output low.
     DDRB |= (1<<7);
     PORTB &= ~(1<<7);
-    
-    // Use full 16-bit resolution. 
+
+    // Use full 16-bit resolution.
     ICR1 = 0xFFFF;
 
     // I could write a wall of text here to explain... but TL;DW
     // Go read the ATmega32u4 datasheet.
     // And this: http://blog.saikoled.com/post/43165849837/secret-konami-cheat-code-to-high-resolution-pwm-on
-    
+
     // Pin PB7 = OCR1C (Timer 1, Channel C)
     // Compare Output Mode = Clear on compare match, Channel C = COM1C1=1 COM1C0=0
     // (i.e. start high, go low when counter matches.)
     // WGM Mode 14 (Fast PWM) = WGM13=1 WGM12=1 WGM11=1 WGM10=0
     // Clock Select = clk/1 (no prescaling) = CS12=0 CS11=0 CS10=1
-    
+
     TCCR1A = _BV(COM1C1) | _BV(WGM11); // = 0b00001010;
     TCCR1B = _BV(WGM13) | _BV(WGM12) | _BV(CS10); // = 0b00011001;
 
@@ -100,7 +96,7 @@ void backlight_set(uint8_t level)
         // Set the brightness
         CHANNEL = 0xFFFF;
     }
-    else        
+    else
     {
         // Turn on PWM control of PB7
         TCCR1A |= _BV(COM1C1);
@@ -303,4 +299,4 @@ ISR(TIMER1_COMPA_vect)
 
 
 
-#endif
\ No newline at end of file
+#endif