#define VENDOR_ID 0xFEED
-#define PRODUCT_ID 0xCAFE
+#define PRODUCT_ID 0x4242
#define DEVICE_VER 0x0104
#define MANUFACTURER t.m.k.
#define PRODUCT HHKB mod
/* matrix size */
-#define MATRIX_ROWS 8
+#ifdef HHKB_JP
+# define MATRIX_ROWS 16
+#else
+# define MATRIX_ROWS 8
+#endif
#define MATRIX_COLS 8
/* Boot Magic salt key: Space */
#define BOOTMAGIC_KEY_SALT KC_FN6
+/* power control of key switch board */
+#define HHKB_POWER_SAVING
/*
* Hardware Serial(UART)
#define RTSEN 0
#define CTSEN 1
- #define SERIAL_UART_BAUD 115200
- #define SERIAL_UART_DATA UDR1
- #define SERIAL_UART_UBRR ((F_CPU/(16.0*SERIAL_UART_BAUD)-1+0.5))
- #define SERIAL_UART_RXD_VECT USART1_RX_vect
- #define SERIAL_UART_TXD_READY (UCSR1A&(1<<UDRE1))
- #define SERIAL_UART_INIT() do { \
+ #define SERIAL_UART_BAUD 115200
+ #define SERIAL_UART_DATA UDR1
+ #define SERIAL_UART_UBRR ((F_CPU/(16.0*SERIAL_UART_BAUD)-1+0.5))
+ #define SERIAL_UART_RXD_VECT USART1_RX_vect
+ #define SERIAL_UART_TXD_READY (UCSR1A&(1<<UDRE1))
+ #define SERIAL_UART_INIT() do { \
UBRR1L = (uint8_t) SERIAL_UART_UBRR; /* baud rate */ \
UBRR1H = ((uint16_t)SERIAL_UART_UBRR>>8); /* baud rate */ \
UCSR1B |= (1<<RXCIE1) | (1<<RXEN1); /* RX interrupt, RX: enable */ \
UCSR1B |= (0<<TXCIE1) | (1<<TXEN1); /* TX interrupt, TX: enable */ \
UCSR1C |= (0<<UPM11) | (0<<UPM10); /* parity: none(00), even(01), odd(11) */ \
- UCSR1D |= (0<<RTSEN) | (0<<CTSEN); /* RTS, CTS */ \
+ UCSR1D |= (0<<RTSEN) | (0<<CTSEN); /* RTS, CTS(no flow control by hardware) */ \
+ DDRD |= (1<<5); PORTD &= ~(1<<5); /* RTS for flow control by firmware */ \
sei(); \
} while(0)
+ #define SERIAL_UART_RTS_LO() do { PORTD &= ~(1<<5); } while (0)
+ #define SERIAL_UART_RTS_HI() do { PORTD |= (1<<5); } while (0)
#else
#error "USART configuration is needed."
#endif