Fix some of the more obvious typos

[qmk_firmware.git] / docs / feature_stenography.md

diff --git a/docs/feature_stenography.md b/docs/feature_stenography.md
index 5b457a2a6c15e3b449ee8415d7c609d314a77e06..9fb224b5da0e1da55f4876fab9a8406b94796c4f 100644 (file)
--- a/docs/feature_stenography.md
+++ b/docs/feature_stenography.md
@@ -14,7 +14,7 @@ To use Plover with QMK just enable NKRO and optionally adjust your layout if you
 
 Plover also understands the language of several steno machines. QMK can speak a couple of these languages, TX Bolt and GeminiPR. An example layout can be found in `planck/keymaps/steno`.
 
-When QMK speaks to Plover over a steno protocol Plover will not use the keyboard as input. This means that you can switch back and forth between a standard keyboard and your steno keyboard, or even switch layers from Plover to standard and back without needing to activate/deactive Plover.
+When QMK speaks to Plover over a steno protocol Plover will not use the keyboard as input. This means that you can switch back and forth between a standard keyboard and your steno keyboard, or even switch layers from Plover to standard and back without needing to activate/deactivate Plover.
 
 In this mode Plover expects to speak with a steno machine over a serial port so QMK will present itself to the operating system as a virtual serial port in addition to a keyboard. By default QMK will speak the TX Bolt protocol but can be switched to GeminiPR; the last protocol used is stored in non-volatile memory so QMK will use the same protocol on restart.