Additional changes for Layer State typedef compatibility (#5906)

[qmk_firmware.git] / docs / custom_quantum_functions.md

diff --git a/docs/custom_quantum_functions.md b/docs/custom_quantum_functions.md
index 6287b9530909e596d44095d6f0162d3774c15f7f..839d49ca0561f8f63ed1968311bb8ee293db5e2e 100644 (file)
--- a/docs/custom_quantum_functions.md
+++ b/docs/custom_quantum_functions.md
@@ -267,7 +267,7 @@ You should use this function if you need custom matrix scanning code. It can als
 
 If the board supports it, it can be "idled", by stopping a number of functions.  A good example of this is RGB lights or backlights.   This can save on power consumption, or may be better behavior for your keyboard.
 
-This is controlled by two functions: `suspend_power_down_*` and `suspend_wakeup_init_*`, which are called when the system is board is idled and when it wakes up, respectively.
+This is controlled by two functions: `suspend_power_down_*` and `suspend_wakeup_init_*`, which are called when the system board is idled and when it wakes up, respectively.
 
 
 ### Example suspend_power_down_user() and suspend_wakeup_init_user() Implementation
@@ -297,8 +297,8 @@ This runs code every time that the layers get changed.  This can be useful for l
 This example shows how to set the [RGB Underglow](feature_rgblight.md) lights based on the layer, using the Planck as an example
 
 ```c
-uint32_t layer_state_set_user(uint32_t state) {
-    switch (biton32(state)) {
+layer_state_t layer_state_set_user(layer_state_t state) {
+    switch (get_highest_layer(state)) {
     case _RAISE:
         rgblight_setrgb (0x00,  0x00, 0xFF);
         break;
@@ -320,8 +320,8 @@ uint32_t layer_state_set_user(uint32_t state) {
 ```
 ### `layer_state_set_*` Function Documentation
 
-* Keyboard/Revision: `uint32_t layer_state_set_kb(uint32_t state)`
-* Keymap: `uint32_t layer_state_set_user(uint32_t state)`
+* Keyboard/Revision: `layer_state_t layer_state_set_kb(layer_state_t state)`
+* Keymap: `layer_state_t layer_state_set_user(layer_state_t state)`
 
 
 The `state` is the bitmask of the active layers, as explained in the [Keymap Overview](keymap.md#keymap-layer-status)
@@ -377,8 +377,8 @@ void keyboard_post_init_user(void) {
 The above function will use the EEPROM config immediately after reading it, to set the default layer's RGB color. The "raw" value of it is converted in a usable structure based on the "union" that you created above. 
 
 ```c
-uint32_t layer_state_set_user(uint32_t state) {
-    switch (biton32(state)) {
+layer_state_t layer_state_set_user(layer_state_t state) {
+    switch (get_highest_layer(state)) {
     case _RAISE:
         if (user_config.rgb_layer_change) { rgblight_sethsv_noeeprom_magenta(); rgblight_mode_noeeprom(1); }
         break;