turn on permissive hold for my keymap (#3295)

[qmk_firmware.git] / docs / config_options.md

diff --git a/docs/config_options.md b/docs/config_options.md
index af8602c3ff99d7b8395ee07c96372442bc97b791..8cdcc97e4959d3409731a5eec6bb774ee9b37604 100644 (file)
--- a/docs/config_options.md
+++ b/docs/config_options.md
@@ -61,10 +61,18 @@ This is a C header file that is one of the first things included, and will persi
   * COL2ROW or ROW2COL - how your matrix is configured. COL2ROW means the black mark on your diode is facing to the rows, and between the switch and the rows.
 * `#define AUDIO_VOICES`
   * turns on the alternate audio voices (to cycle through)
+* `#define C4_AUDIO`
+  * enables audio on pin C4
+* `#define C5_AUDIO`
+  * enables audio on pin C5
 * `#define C6_AUDIO`
   * enables audio on pin C6
 * `#define B5_AUDIO`
-  * enables audio on pin B5 (duophony is enable if both are enabled)
+  * enables audio on pin B5 (duophony is enables if one of B[5-7]_AUDIO is enabled along with one of C[4-6]_AUDIO)
+* `#define B6_AUDIO`
+  * enables audio on pin B6 (duophony is enables if one of B[5-7]_AUDIO is enabled along with one of C[4-6]_AUDIO)
+* `#define B7_AUDIO`
+  * enables audio on pin B7 (duophony is enables if one of B[5-7]_AUDIO is enabled along with one of C[4-6]_AUDIO)
 * `#define BACKLIGHT_PIN B7`
   * pin of the backlight - B5, B6, B7 use PWM, others use softPWM
 * `#define BACKLIGHT_LEVELS 3`
@@ -81,6 +89,8 @@ This is a C header file that is one of the first things included, and will persi
   * tries to keep switch state consistent with keyboard LED state
 * `#define IS_COMMAND() ( keyboard_report->mods == (MOD_BIT(KC_LSHIFT) | MOD_BIT(KC_RSHIFT)) )`
   * key combination that allows the use of magic commands (useful for debugging)
+* `#define USB_MAX_POWER_CONSUMPTION`
+  * sets the maximum power (in mA) over USB for the device (default: 500)
 
 ## Features That Can Be Disabled
 
@@ -108,7 +118,7 @@ If you define these options you will enable the associated feature, which may in
 * `#define FORCE_NKRO`
   * NKRO by default requires to be turned on, this forces it on during keyboard startup regardless of EEPROM setting. NKRO can still be turned off but will be turned on again if the keyboard reboots.
 * `#define PREVENT_STUCK_MODIFIERS`
-  * when switching layers, this will release all mods
+  * stores the layer a key press came from so the same layer is used when the key is released, regardless of which layers are enabled
 
 ## Behaviors That Can Be Configured