3 # project specific files
4 SRC = keyboards/zeal60/zeal60.c \
5 keyboards/zeal60/rgb_backlight.c \
7 drivers/issi/is31fl3731.c \
8 drivers/avr/i2c_master.c
13 # Processor frequency.
14 # This will define a symbol, F_CPU, in all source code files equal to the
15 # processor frequency in Hz. You can then use this symbol in your source code to
16 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
17 # automatically to create a 32-bit value in your source code.
19 # This will be an integer division of F_USB below, as it is sourced by
20 # F_USB after it has run through any CPU prescalers. Note that this value
21 # does not *change* the processor frequency - it should merely be updated to
22 # reflect the processor speed set externally so that the code can use accurate
29 # Target architecture (see library "Board Types" documentation).
32 # Input clock frequency.
33 # This will define a symbol, F_USB, in all source code files equal to the
34 # input clock frequency (before any prescaling is performed) in Hz. This value may
35 # differ from F_CPU if prescaling is used on the latter, and is required as the
36 # raw input clock is fed directly to the PLL sections of the AVR for high speed
37 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
38 # at the end, this will be done automatically to create a 32-bit value in your
41 # If no clock division is performed on the input clock inside the AVR (via the
42 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
45 # Interrupt driven control endpoint task(+60)
46 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
49 BOOTLOADER = atmel-dfu
51 # Do not put the microcontroller into power saving mode
52 # when we get USB suspend event. We want it to keep updating
54 OPT_DEFS += -DNO_SUSPEND_POWER_DOWN
57 # change to "no" to disable the options, or define them in the Makefile in
58 # the appropriate keymap folder that will get included automatically
60 BOOTMAGIC_ENABLE = no # Virtual DIP switch configuration(+1000)
61 MOUSEKEY_ENABLE = no # Mouse keys(+4700)
62 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
63 CONSOLE_ENABLE = no # Console for debug(+400)
64 COMMAND_ENABLE = no # Commands for debug and configuration
65 NKRO_ENABLE = yes # Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
66 BACKLIGHT_ENABLE = no # Enable keyboard backlight functionality
67 MIDI_ENABLE = no # MIDI controls
68 AUDIO_ENABLE = no # Audio output on port C6
69 UNICODE_ENABLE = no # Unicode
70 BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID
71 RGBLIGHT_ENABLE = no # Enable WS2812 RGB underlight.
73 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
74 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
77 DYNAMIC_KEYMAP_ENABLE = yes