6 # This will define a symbol, F_CPU, in all source code files equal to the
7 # processor frequency in Hz. You can then use this symbol in your source code to
8 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
9 # automatically to create a 32-bit value in your source code.
11 # This will be an integer division of F_USB below, as it is sourced by
12 # F_USB after it has run through any CPU prescalers. Note that this value
13 # does not *change* the processor frequency - it should merely be updated to
14 # reflect the processor speed set externally so that the code can use accurate
21 # Target architecture (see library "Board Types" documentation).
24 # Input clock frequency.
25 # This will define a symbol, F_USB, in all source code files equal to the
26 # input clock frequency (before any prescaling is performed) in Hz. This value may
27 # differ from F_CPU if prescaling is used on the latter, and is required as the
28 # raw input clock is fed directly to the PLL sections of the AVR for high speed
29 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
30 # at the end, this will be done automatically to create a 32-bit value in your
33 # If no clock division is performed on the input clock inside the AVR (via the
34 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
38 # This definition is optional, and if your keyboard supports multiple bootloaders of
39 # different sizes, comment this out, and the correct address will be loaded
40 # automatically (+60). See bootloader.mk for all options.
43 # Interrupt driven control endpoint task(+60)
44 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
46 # Custom local font file
47 OPT_DEFS += -DOLED_FONT_H=\"common/glcdfont.c\"
53 # change to "no" to disable the options, or define them in the Makefile in
54 # the appropriate keymap folder that will get included automatically
56 BOOTMAGIC_ENABLE = no # Virtual DIP switch configuration(+1000)
57 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
58 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
59 CONSOLE_ENABLE = no # Console for debug(+400)
60 COMMAND_ENABLE = yes # Commands for debug and configuration
61 NKRO_ENABLE = no # Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
62 UNICODE_ENABLE = no # Unicode
63 BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID
64 RGBLIGHT_ENABLE = yes # Enable WS2812 RGB underlight. Do not enable this with audio at the same time.
66 DEFAULT_FOLDER = rgbkb/sol/rev1