2 OPT_DEFS += -DMITOSIS_PROMICRO
3 OPT_DEFS += -DCATERINA_BOOTLOADER
4 MITOSIS_UPLOAD_COMMAND = while [ ! -r $(USB) ]; do sleep 1; done; \
5 avrdude -p $(MCU) -c avr109 -U flash:w:$(TARGET).hex -P $(USB)
7 # # project specific files
15 # Processor frequency.
16 # This will define a symbol, F_CPU, in all source code files equal to the
17 # processor frequency in Hz. You can then use this symbol in your source code to
18 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
19 # automatically to create a 32-bit value in your source code.
21 # This will be an integer division of F_USB below, as it is sourced by
22 # F_USB after it has run through any CPU prescalers. Note that this value
23 # does not *change* the processor frequency - it should merely be updated to
24 # reflect the processor speed set externally so that the code can use accurate
32 # Target architecture (see library "Board Types" documentation).
35 # Input clock frequency.
36 # This will define a symbol, F_USB, in all source code files equal to the
37 # input clock frequency (before any prescaling is performed) in Hz. This value may
38 # differ from F_CPU if prescaling is used on the latter, and is required as the
39 # raw input clock is fed directly to the PLL sections of the AVR for high speed
40 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
41 # at the end, this will be done automatically to create a 32-bit value in your
44 # If no clock division is performed on the input clock inside the AVR (via the
45 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
48 # Interrupt driven control endpoint task(+60)
49 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
52 # Boot Section Size in *bytes*
54 # Teensy++ halfKay 1024
55 # Atmel DFU loader 4096
56 # LUFA bootloader 4096
58 OPT_DEFS += -DBOOTLOADER_SIZE=4096
62 # comment out to disable the options.
64 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
65 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
66 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
67 CONSOLE_ENABLE = yes # Console for debug(+400)
68 COMMAND_ENABLE = yes # Commands for debug and configuration
69 CUSTOM_MATRIX = yes # Remote matrix from the wireless bridge
70 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
71 # SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
72 NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
73 # BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality
74 # MIDI_ENABLE = YES # MIDI controls
75 UNICODE_ENABLE = YES # Unicode
76 # BLUETOOTH_ENABLE = yes # Enable Bluetooth with the Adafruit EZ-Key HID
81 $(MITOSIS_UPLOAD_COMMAND)