1 # project specific files
9 # This will define a symbol, F_CPU, in all source code files equal to the
10 # processor frequency in Hz. You can then use this symbol in your source code to
11 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
12 # automatically to create a 32-bit value in your source code.
14 # This will be an integer division of F_USB below, as it is sourced by
15 # F_USB after it has run through any CPU prescalers. Note that this value
16 # does not *change* the processor frequency - it should merely be updated to
17 # reflect the processor speed set externally so that the code can use accurate
25 # Target architecture (see library "Board Types" documentation).
28 # Input clock frequency.
29 # This will define a symbol, F_USB, in all source code files equal to the
30 # input clock frequency (before any prescaling is performed) in Hz. This value may
31 # differ from F_CPU if prescaling is used on the latter, and is required as the
32 # raw input clock is fed directly to the PLL sections of the AVR for high speed
33 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
34 # at the end, this will be done automatically to create a 32-bit value in your
37 # If no clock division is performed on the input clock inside the AVR (via the
38 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
41 # Interrupt driven control endpoint task(+60)
42 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
45 # Boot Section Size in *bytes*
47 # Teensy++ halfKay 1024
48 # Atmel DFU loader 4096
49 # LUFA bootloader 4096
51 OPT_DEFS += -DBOOTLOADER_SIZE=4096
55 # change yes to no to disable
57 BOOTMAGIC_ENABLE ?= no # Virtual DIP switch configuration(+1000)
58 MOUSEKEY_ENABLE ?= yes # Mouse keys(+4700)
59 EXTRAKEY_ENABLE ?= yes # Audio control and System control(+450)
60 CONSOLE_ENABLE ?= yes # Console for debug(+400)
61 COMMAND_ENABLE ?= yes # Commands for debug and configuration
62 KEYBOARD_LOCK_ENABLE ?= yes # Allow locking of keyboard via magic key
63 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
64 SLEEP_LED_ENABLE ?= no # Breathing sleep LED during USB suspend
65 # if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
66 NKRO_ENABLE ?= no # USB Nkey Rollover
67 BACKLIGHT_ENABLE ?= yes # Enable keyboard backlight functionality
68 MIDI_ENABLE ?= no # MIDI controls
69 UNICODE_ENABLE ?= no # Unicode
70 BLUETOOTH_ENABLE ?= no # Enable Bluetooth with the Adafruit EZ-Key HID
71 AUDIO_ENABLE ?= no # Audio output on port C6