1 #----------------------------------------------------------------------------
4 # make = Make software.
6 # make clean = Clean out built project files.
8 # That's pretty much all you need. To compile, always go make clean,
11 # For advanced users only:
12 # make teensy = Download the hex file to the device, using teensy_loader_cli.
13 # (must have teensy_loader_cli installed).
15 #----------------------------------------------------------------------------
17 # # project specific files
25 # Processor frequency.
26 # This will define a symbol, F_CPU, in all source code files equal to the
27 # processor frequency in Hz. You can then use this symbol in your source code to
28 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
29 # automatically to create a 32-bit value in your source code.
31 # This will be an integer division of F_USB below, as it is sourced by
32 # F_USB after it has run through any CPU prescalers. Note that this value
33 # does not *change* the processor frequency - it should merely be updated to
34 # reflect the processor speed set externally so that the code can use accurate
41 # Target architecture (see library "Board Types" documentation).
44 # Input clock frequency.
45 # This will define a symbol, F_USB, in all source code files equal to the
46 # input clock frequency (before any prescaling is performed) in Hz. This value may
47 # differ from F_CPU if prescaling is used on the latter, and is required as the
48 # raw input clock is fed directly to the PLL sections of the AVR for high speed
49 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
50 # at the end, this will be done automatically to create a 32-bit value in your
53 # If no clock division is performed on the input clock inside the AVR (via the
54 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
57 # Interrupt driven control endpoint task(+60)
58 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
61 BOOTLOADER = atmel-dfu
64 # comment out to disable the options.
66 CUSTOM_MATRIX = yes # Custom matrix file for the ErgoDone
67 UNICODE_ENABLE = yes # Unicode
68 BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
69 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
70 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
71 CONSOLE_ENABLE = yes # Console for debug(+400)
72 COMMAND_ENABLE = no # Commands for debug and configuration
73 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
74 NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
75 USB_6KRO_ENABLE = no # USB 6key Rollover
76 BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality
77 KEYMAP_SECTION_ENABLE = no # Fixed address keymap for keymap editor
78 SWAP_HANDS_ENABLE = no # Disable Onehand