1 # # project specific files
10 # This will define a symbol, F_CPU, in all source code files equal to the
11 # processor frequency in Hz. You can then use this symbol in your source code to
12 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
13 # automatically to create a 32-bit value in your source code.
15 # This will be an integer division of F_USB below, as it is sourced by
16 # F_USB after it has run through any CPU prescalers. Note that this value
17 # does not *change* the processor frequency - it should merely be updated to
18 # reflect the processor speed set externally so that the code can use accurate
26 # Target architecture (see library "Board Types" documentation).
29 # Input clock frequency.
30 # This will define a symbol, F_USB, in all source code files equal to the
31 # input clock frequency (before any prescaling is performed) in Hz. This value may
32 # differ from F_CPU if prescaling is used on the latter, and is required as the
33 # raw input clock is fed directly to the PLL sections of the AVR for high speed
34 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
35 # at the end, this will be done automatically to create a 32-bit value in your
38 # If no clock division is performed on the input clock inside the AVR (via the
39 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
42 # Interrupt driven control endpoint task(+60)
43 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
48 # comment out to disable the options.
50 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
51 #MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
52 POINTING_DEVICE_ENABLE = yes # Generic Pointer, not as big as mouse keys hopefully.
53 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
54 CONSOLE_ENABLE = yes # Console for debug(+400)
55 COMMAND_ENABLE = yes # Commands for debug and configuration
56 CUSTOM_MATRIX = yes # Remote matrix from the wireless bridge
57 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
58 # SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
59 NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
60 # BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality
61 # MIDI_ENABLE = YES # MIDI controls
62 UNICODE_ENABLE = YES # Unicode
63 # BLUETOOTH_ENABLE = yes # Enable Bluetooth with the Adafruit EZ-Key HID
68 # $(honeycomb_UPLOAD_COMMAND)