1 # # project specific files
9 # This will define a symbol, F_CPU, in all source code files equal to the
10 # processor frequency in Hz. You can then use this symbol in your source code to
11 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
12 # automatically to create a 32-bit value in your source code.
14 # This will be an integer division of F_USB below, as it is sourced by
15 # F_USB after it has run through any CPU prescalers. Note that this value
16 # does not *change* the processor frequency - it should merely be updated to
17 # reflect the processor speed set externally so that the code can use accurate
25 # Target architecture (see library "Board Types" documentation).
28 # Input clock frequency.
29 # This will define a symbol, F_USB, in all source code files equal to the
30 # input clock frequency (before any prescaling is performed) in Hz. This value may
31 # differ from F_CPU if prescaling is used on the latter, and is required as the
32 # raw input clock is fed directly to the PLL sections of the AVR for high speed
33 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
34 # at the end, this will be done automatically to create a 32-bit value in your
37 # If no clock division is performed on the input clock inside the AVR (via the
38 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
41 # Interrupt driven control endpoint task(+60)
42 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
47 # comment out to disable the options.
49 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
50 #MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
51 POINTING_DEVICE_ENABLE = yes # Generic Pointer, not as big as mouse keys hopefully.
52 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
53 CONSOLE_ENABLE = yes # Console for debug(+400)
54 COMMAND_ENABLE = yes # Commands for debug and configuration
55 CUSTOM_MATRIX = yes # Remote matrix from the wireless bridge
56 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
57 # SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
58 NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
59 # BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality
60 # MIDI_ENABLE = YES # MIDI controls
61 UNICODE_ENABLE = YES # Unicode
62 # BLUETOOTH_ENABLE = yes # Enable Bluetooth with the Adafruit EZ-Key HID
67 # $(honeycomb_UPLOAD_COMMAND)