3 # project specific files
10 # Processor frequency.
11 # This will define a symbol, F_CPU, in all source code files equal to the
12 # processor frequency in Hz. You can then use this symbol in your source code to
13 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
14 # automatically to create a 32-bit value in your source code.
16 # This will be an integer division of F_USB below, as it is sourced by
17 # F_USB after it has run through any CPU prescalers. Note that this value
18 # does not *change* the processor frequency - it should merely be updated to
19 # reflect the processor speed set externally so that the code can use accurate
27 # Target architecture (see library "Board Types" documentation).
30 # Input clock frequency.
31 # This will define a symbol, F_USB, in all source code files equal to the
32 # input clock frequency (before any prescaling is performed) in Hz. This value may
33 # differ from F_CPU if prescaling is used on the latter, and is required as the
34 # raw input clock is fed directly to the PLL sections of the AVR for high speed
35 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
36 # at the end, this will be done automatically to create a 32-bit value in your
39 # If no clock division is performed on the input clock inside the AVR (via the
40 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
43 # Interrupt driven control endpoint task(+60)
44 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
47 # Boot Section Size in *bytes*
49 # Teensy++ halfKay 1024
50 # Atmel DFU loader 4096
51 # LUFA bootloader 4096
53 #OPT_DEFS += -DBOOTLOADER_SIZE=4096
55 # as per original hasu settings
56 OPT_DEFS += -DBOOTLOADER_SIZE=4096
59 # comment out to disable the options.
61 BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
62 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
63 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
64 CONSOLE_ENABLE = yes # Console for debug(+400)
65 COMMAND_ENABLE = yes # Commands for debug and configuration
66 CUSTOM_MATRIX = yes # Custom matrix file for the HHKB
67 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
68 # SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
69 # NKRO_ENABLE = yes # USB Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
70 # BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality
71 # MIDI_ENABLE = yes # MIDI controls
72 # UNICODE_ENABLE = yes # Unicode
73 # BLUETOOTH_ENABLE = yes # Enable Bluetooth with the Adafruit EZ-Key HID
75 # debug-on: EXTRAFLAGS += -DDEBUG -DDEBUG_ACTION
78 # debug-off: EXTRAFLAGS += -DNO_DEBUG -DNO_PRINT
79 # debug-off: OPT_DEFS := $(filter-out -DCONSOLE_ENABLE,$(OPT_DEFS))