6 # This will define a symbol, F_CPU, in all source code files equal to the
7 # processor frequency in Hz. You can then use this symbol in your source code to
8 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
9 # automatically to create a 32-bit value in your source code.
11 # This will be an integer division of F_USB below, as it is sourced by
12 # F_USB after it has run through any CPU prescalers. Note that this value
13 # does not *change* the processor frequency - it should merely be updated to
14 # reflect the processor speed set externally so that the code can use accurate
19 USB ?= /dev/cu.usbmodem1421
23 # Target architecture (see library "Board Types" documentation).
26 # Input clock frequency.
27 # This will define a symbol, F_USB, in all source code files equal to the
28 # input clock frequency (before any prescaling is performed) in Hz. This value may
29 # differ from F_CPU if prescaling is used on the latter, and is required as the
30 # raw input clock is fed directly to the PLL sections of the AVR for high speed
31 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
32 # at the end, this will be done automatically to create a 32-bit value in your
35 # If no clock division is performed on the input clock inside the AVR (via the
36 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
41 OPT_DEFS += -DATREUS_TEENSY2
42 ATREUS_UPLOAD_COMMAND = teensy_loader_cli -w -mmcu=$(MCU) $(TARGET).hex
44 OPT_DEFS += -DATREUS_ASTAR
45 OPT_DEFS += -DCATERINA_BOOTLOADER
46 ATREUS_UPLOAD_COMMAND = while [ ! -r $(USB) ]; do sleep 1; done; \
47 avrdude -p $(MCU) -c avr109 -U flash:w:$(TARGET).hex -P $(USB)
49 # Interrupt driven control endpoint task(+60)
50 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
55 # Boot Section Size in *bytes*
57 # Teensy++ halfKay 1024
58 # Atmel DFU loader 4096
59 # LUFA bootloader 4096
61 OPT_DEFS += -DBOOTLOADER_SIZE=4096
65 # change yes to no to disable
67 BOOTMAGIC_ENABLE ?= no # Virtual DIP switch configuration(+1000)
68 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
69 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
70 CONSOLE_ENABLE ?= no # Console for debug(+400)
71 COMMAND_ENABLE ?= no # Commands for debug and configuration
72 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
73 SLEEP_LED_ENABLE ?= no # Breathing sleep LED during USB suspend
74 # if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
75 NKRO_ENABLE ?= no # USB Nkey Rollover
76 BACKLIGHT_ENABLE ?= no # Enable keyboard backlight functionality on B7 by default
77 MIDI_ENABLE ?= no # MIDI controls
78 UNICODE_ENABLE ?= no # Unicode
79 BLUETOOTH_ENABLE ?= no # Enable Bluetooth with the Adafruit EZ-Key HID
80 AUDIO_ENABLE ?= no # Audio output on port C6
83 include ../../../Makefile
87 $(ATREUS_UPLOAD_COMMAND)