5 # This will define a symbol, F_CPU, in all source code files equal to the
6 # processor frequency in Hz. You can then use this symbol in your source code to
7 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
8 # automatically to create a 32-bit value in your source code.
10 # This will be an integer division of F_USB below, as it is sourced by
11 # F_USB after it has run through any CPU prescalers. Note that this value
12 # does not *change* the processor frequency - it should merely be updated to
13 # reflect the processor speed set externally so that the code can use accurate
18 USB = /dev/cu.usbmodem1421
22 # Target architecture (see library "Board Types" documentation).
25 # Input clock frequency.
26 # This will define a symbol, F_USB, in all source code files equal to the
27 # input clock frequency (before any prescaling is performed) in Hz. This value may
28 # differ from F_CPU if prescaling is used on the latter, and is required as the
29 # raw input clock is fed directly to the PLL sections of the AVR for high speed
30 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
31 # at the end, this will be done automatically to create a 32-bit value in your
34 # If no clock division is performed on the input clock inside the AVR (via the
35 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
39 # This definition is optional, and if your keyboard supports multiple bootloaders of
40 # different sizes, comment this out, and the correct address will be loaded
41 # automatically (+60). See bootloader.mk for all options.
44 OPT_DEFS += -DATREUS_TEENSY2
45 ATREUS_UPLOAD_COMMAND = teensy_loader_cli -w -mmcu=$(MCU) $(TARGET).hex
48 OPT_DEFS += -DATREUS_ASTAR
49 ATREUS_UPLOAD_COMMAND = while [ ! -r $(USB) ]; do sleep 1; done; \
50 avrdude -p $(MCU) -c avr109 -U flash:w:$(TARGET).hex -P $(USB)
53 # Interrupt driven control endpoint task(+60)
54 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
59 # change yes to no to disable
61 BOOTMAGIC_ENABLE = no # Virtual DIP switch configuration(+1000)
62 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
63 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
64 CONSOLE_ENABLE = no # Console for debug(+400)
65 COMMAND_ENABLE = no # Commands for debug and configuration
66 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
67 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
68 # if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
69 NKRO_ENABLE = no # USB Nkey Rollover
70 BACKLIGHT_ENABLE = no # Enable keyboard backlight functionality on B7 by default
71 MIDI_ENABLE = no # MIDI controls
72 UNICODE_ENABLE = no # Unicode
73 BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID
74 AUDIO_ENABLE = no # Audio output on port C6
77 # $(ATREUS_UPLOAD_COMMAND)