1 # see https://github.com/pepaslabs/hexon38
7 # This will define a symbol, F_CPU, in all source code files equal to the
8 # processor frequency in Hz. You can then use this symbol in your source code to
9 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
10 # automatically to create a 32-bit value in your source code.
12 # This will be an integer division of F_USB below, as it is sourced by
13 # F_USB after it has run through any CPU prescalers. Note that this value
14 # does not *change* the processor frequency - it should merely be updated to
15 # reflect the processor speed set externally so that the code can use accurate
22 # Target architecture (see library "Board Types" documentation).
25 # Input clock frequency.
26 # This will define a symbol, F_USB, in all source code files equal to the
27 # input clock frequency (before any prescaling is performed) in Hz. This value may
28 # differ from F_CPU if prescaling is used on the latter, and is required as the
29 # raw input clock is fed directly to the PLL sections of the AVR for high speed
30 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
31 # at the end, this will be done automatically to create a 32-bit value in your
34 # If no clock division is performed on the input clock inside the AVR (via the
35 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
38 # Interrupt driven control endpoint task(+60)
39 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
42 # Bootloader selection
48 # atmega32a bootloadHID
52 # Enabled build options:
53 BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
54 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
55 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
56 CONSOLE_ENABLE = yes # Console for debug(+400)
57 COMMAND_ENABLE = yes # Commands for debug and configuration
58 NKRO_ENABLE = yes # USB Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
60 # Disabled build options:
61 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
62 BACKLIGHT_ENABLE = no # Enable keyboard backlight functionality