4 # project specific files
8 # This will define a symbol, F_CPU, in all source code files equal to the
9 # processor frequency in Hz. You can then use this symbol in your source code to
10 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
11 # automatically to create a 32-bit value in your source code.
13 # This will be an integer division of F_USB below, as it is sourced by
14 # F_USB after it has run through any CPU prescalers. Note that this value
15 # does not *change* the processor frequency - it should merely be updated to
16 # reflect the processor speed set externally so that the code can use accurate
24 # Target architecture (see library "Board Types" documentation).
27 # Input clock frequency.
28 # This will define a symbol, F_USB, in all source code files equal to the
29 # input clock frequency (before any prescaling is performed) in Hz. This value may
30 # differ from F_CPU if prescaling is used on the latter, and is required as the
31 # raw input clock is fed directly to the PLL sections of the AVR for high speed
32 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
33 # at the end, this will be done automatically to create a 32-bit value in your
36 # If no clock division is performed on the input clock inside the AVR (via the
37 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
40 # Interrupt driven control endpoint task(+60)
41 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
46 # Do not put the microcontroller into power saving mode
47 # when we get USB suspend event. We want it to keep updating
51 # change yes to no to disable
53 BOOTMAGIC_ENABLE = lite # Virtual DIP switch configuration(+1000)
54 MOUSEKEY_ENABLE = no # Mouse keys(+4700)
55 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
56 CONSOLE_ENABLE = no # Console for debug(+400)
57 COMMAND_ENABLE = no # Commands for debug and configuration
58 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
59 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
60 # if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
61 NKRO_ENABLE = yes # USB Nkey Rollover
62 BACKLIGHT_ENABLE = no # Enable keyboard backlight functionality on B7 by default
63 MIDI_ENABLE = no # MIDI support (+2400 to 4200, depending on config)
64 UNICODE_ENABLE = no # Unicode
65 BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID
66 AUDIO_ENABLE = no # Audio output on port C6
67 FAUXCLICKY_ENABLE = no # Use buzzer to emulate clicky switches
68 RGB_MATRIX_ENABLE = yes # Use RGB matrix