7 # This will define a symbol, F_CPU, in all source code files equal to the
8 # processor frequency in Hz. You can then use this symbol in your source code to
9 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
10 # automatically to create a 32-bit value in your source code.
12 # This will be an integer division of F_USB below, as it is sourced by
13 # F_USB after it has run through any CPU prescalers. Note that this value
14 # does not *change* the processor frequency - it should merely be updated to
15 # reflect the processor speed set externally so that the code can use accurate
22 # Target architecture (see library "Board Types" documentation).
25 # Input clock frequency.
26 # This will define a symbol, F_USB, in all source code files equal to the
27 # input clock frequency (before any prescaling is performed) in Hz. This value may
28 # differ from F_CPU if prescaling is used on the latter, and is required as the
29 # raw input clock is fed directly to the PLL sections of the AVR for high speed
30 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
31 # at the end, this will be done automatically to create a 32-bit value in your
34 # If no clock division is performed on the input clock inside the AVR (via the
35 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
39 # This definition is optional, and if your keyboard supports multiple bootloaders of
40 # different sizes, comment this out, and the correct address will be loaded
41 # automatically (+60). See bootloader.mk for all options.
44 # Interrupt driven control endpoint task(+60)
45 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
48 # change to "no" to disable the options, or define them in the Makefile in
49 # the appropriate keymap folder that will get included automatically
51 BOOTMAGIC_ENABLE = no # Virtual DIP switch configuration(+1000)
52 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
53 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
54 CONSOLE_ENABLE = no # Console for debug(+400)
55 COMMAND_ENABLE = yes # Commands for debug and configuration
56 NKRO_ENABLE = no # Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
57 BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality
58 MIDI_ENABLE = no # MIDI controls
59 AUDIO_ENABLE = no # Audio output on port C6
60 UNICODE_ENABLE = no # Unicode
61 BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID
62 RGBLIGHT_ENABLE = yes # Enable WS2812 RGB underlight.
63 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
64 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
68 DEFAULT_FOLDER = ergotravel/rev1