6 # This will define a symbol, F_CPU, in all source code files equal to the
7 # processor frequency in Hz. You can then use this symbol in your source code to
8 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
9 # automatically to create a 32-bit value in your source code.
11 # This will be an integer division of F_USB below, as it is sourced by
12 # F_USB after it has run through any CPU prescalers. Note that this value
13 # does not *change* the processor frequency - it should merely be updated to
14 # reflect the processor speed set externally so that the code can use accurate
20 # Target architecture (see library "Board Types" documentation).
24 # Input clock frequency.
25 # This will define a symbol, F_USB, in all source code files equal to the
26 # input clock frequency (before any prescaling is performed) in Hz. This value may
27 # differ from F_CPU if prescaling is used on the latter, and is required as the
28 # raw input clock is fed directly to the PLL sections of the AVR for high speed
29 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
30 # at the end, this will be done automatically to create a 32-bit value in your
33 # If no clock division is performed on the input clock inside the AVR (via the
34 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
38 # Interrupt driven control endpoint task(+60)
39 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
42 # Boot Section Size in *bytes*
44 # Teensy++ halfKay 1024
45 # Atmel DFU loader 4096
46 # LUFA bootloader 4096
48 OPT_DEFS += -DBOOTLOADER_SIZE=4096
52 AUDIO_ENABLE = no # Audio output on port C6
53 BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality
54 BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID
55 BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
56 COMMAND_ENABLE = no # Commands for debug and configuration
57 CONSOLE_ENABLE = no # Console for debug(+400)
58 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
59 MIDI_ENABLE = no # MIDI controls
60 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
61 NKRO_ENABLE = yes # Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
62 RGBLIGHT_ENABLE = yes # Enable WS2812 RGB underlight. Do not enable this with audio at the same time.
63 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
64 UNICODE_ENABLE = no # Unicode