6 # This will define a symbol, F_CPU, in all source code files equal to the
7 # processor frequency in Hz. You can then use this symbol in your source code to
8 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
9 # automatically to create a 32-bit value in your source code.
11 # This will be an integer division of F_USB below, as it is sourced by
12 # F_USB after it has run through any CPU prescalers. Note that this value
13 # does not *change* the processor frequency - it should merely be updated to
14 # reflect the processor speed set externally so that the code can use accurate
17 # Since there are different hardware variations of these adapters and since these
18 # have different CPU clocks, the clock speed should be set in the rules.mk file of the
19 # respective hardware variantion (i.e. subproject). For example, in /pro_micro/rules.mk
20 # this is set to 8000000.
21 # The value here is only a fallback and is ignored if it is defined in the subproject.
24 DEFAULT_FOLDER = converter/usb_usb/hasu
30 # Target architecture (see library "Board Types" documentation).
33 # Input clock frequency.
34 # This will define a symbol, F_USB, in all source code files equal to the
35 # input clock frequency (before any prescaling is performed) in Hz. This value may
36 # differ from F_CPU if prescaling is used on the latter, and is required as the
37 # raw input clock is fed directly to the PLL sections of the AVR for high speed
38 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
39 # at the end, this will be done automatically to create a 32-bit value in your
42 # If no clock division is performed on the input clock inside the AVR (via the
43 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
47 # This definition is optional, and if your keyboard supports multiple bootloaders of
48 # different sizes, comment this out, and the correct address will be loaded
49 # automatically (+60). See bootloader.mk for all options.
52 # Interrupt driven control endpoint task
53 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
56 # comment out to disable the options.
58 # BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
59 # MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
60 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
61 # CONSOLE_ENABLE = yes # Console for debug(+400)
62 # COMMAND_ENABLE = yes # Commands for debug and configuration
63 # SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
64 # NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
65 # BACKLIGHT_ENABLE = yes
69 SRC = custom_matrix.cpp