1 # # project specific files
10 # This will define a symbol, F_CPU, in all source code files equal to the
11 # processor frequency in Hz. You can then use this symbol in your source code to
12 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
13 # automatically to create a 32-bit value in your source code.
15 # This will be an integer division of F_USB below, as it is sourced by
16 # F_USB after it has run through any CPU prescalers. Note that this value
17 # does not *change* the processor frequency - it should merely be updated to
18 # reflect the processor speed set externally so that the code can use accurate
24 # Target architecture (see library "Board Types" documentation).
27 # Input clock frequency.
28 # This will define a symbol, F_USB, in all source code files equal to the
29 # input clock frequency (before any prescaling is performed) in Hz. This value may
30 # differ from F_CPU if prescaling is used on the latter, and is required as the
31 # raw input clock is fed directly to the PLL sections of the AVR for high speed
32 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
33 # at the end, this will be done automatically to create a 32-bit value in your
36 # If no clock division is performed on the input clock inside the AVR (via the
37 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
41 # This definition is optional, and if your keyboard supports multiple bootloaders of
42 # different sizes, comment this out, and the correct address will be loaded
43 # automatically (+60). See bootloader.mk for all options.
44 # BOOTLOADER = caterina
46 # Interrupt driven control endpoint task(+60)
47 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
50 # comment out to disable the options.
52 BOOTMAGIC_ENABLE = no # Virtual DIP switch configuration(+1000)
53 MOUSEKEY_ENABLE = no # Mouse keys(+4700)
54 EXTRAKEY_ENABLE = no # Audio control and System control(+450)
55 CONSOLE_ENABLE = no # Console for debug(+400)
56 COMMAND_ENABLE = no # Commands for debug and configuration
57 CUSTOM_MATRIX = yes # Remote matrix from the wireless bridge
58 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
59 # SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
60 NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
61 # BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality
62 # MIDI_ENABLE = YES # MIDI controls
63 UNICODE_ENABLE = YES # Unicode
64 # BLUETOOTH_ENABLE = yes # Enable Bluetooth with the Adafruit EZ-Key HID