1 # # project specific files
10 # Processor frequency.
11 # This will define a symbol, F_CPU, in all source code files equal to the
12 # processor frequency in Hz. You can then use this symbol in your source code to
13 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
14 # automatically to create a 32-bit value in your source code.
16 # This will be an integer division of F_USB below, as it is sourced by
17 # F_USB after it has run through any CPU prescalers. Note that this value
18 # does not *change* the processor frequency - it should merely be updated to
19 # reflect the processor speed set externally so that the code can use accurate
25 # Target architecture (see library "Board Types" documentation).
28 # Input clock frequency.
29 # This will define a symbol, F_USB, in all source code files equal to the
30 # input clock frequency (before any prescaling is performed) in Hz. This value may
31 # differ from F_CPU if prescaling is used on the latter, and is required as the
32 # raw input clock is fed directly to the PLL sections of the AVR for high speed
33 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
34 # at the end, this will be done automatically to create a 32-bit value in your
37 # If no clock division is performed on the input clock inside the AVR (via the
38 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
42 # This definition is optional, and if your keyboard supports multiple bootloaders of
43 # different sizes, comment this out, and the correct address will be loaded
44 # automatically (+60). See bootloader.mk for all options.
45 # BOOTLOADER = caterina
47 # Interrupt driven control endpoint task(+60)
48 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
51 # comment out to disable the options.
53 BOOTMAGIC_ENABLE = no # Virtual DIP switch configuration(+1000)
54 MOUSEKEY_ENABLE = no # Mouse keys(+4700)
55 EXTRAKEY_ENABLE = no # Audio control and System control(+450)
56 CONSOLE_ENABLE = no # Console for debug(+400)
57 COMMAND_ENABLE = no # Commands for debug and configuration
58 CUSTOM_MATRIX = yes # Remote matrix from the wireless bridge
59 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
60 # SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
61 NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
62 # BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality
63 # MIDI_ENABLE = YES # MIDI controls
64 UNICODE_ENABLE = YES # Unicode
65 # BLUETOOTH_ENABLE = yes # Enable Bluetooth with the Adafruit EZ-Key HID