5 # This will define a symbol, F_CPU, in all source code files equal to the
6 # processor frequency in Hz. You can then use this symbol in your source code to
7 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
8 # automatically to create a 32-bit value in your source code.
10 # This will be an integer division of F_USB below, as it is sourced by
11 # F_USB after it has run through any CPU prescalers. Note that this value
12 # does not *change* the processor frequency - it should merely be updated to
13 # reflect the processor speed set externally so that the code can use accurate
20 # Target architecture (see library "Board Types" documentation).
23 # Input clock frequency.
24 # This will define a symbol, F_USB, in all source code files equal to the
25 # input clock frequency (before any prescaling is performed) in Hz. This value may
26 # differ from F_CPU if prescaling is used on the latter, and is required as the
27 # raw input clock is fed directly to the PLL sections of the AVR for high speed
28 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
29 # at the end, this will be done automatically to create a 32-bit value in your
32 # If no clock division is performed on the input clock inside the AVR (via the
33 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
36 # Interrupt driven control endpoint task(+60)
37 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
40 # Bootloader selection
46 # atmega32a bootloadHID
49 OPT_DEFS += -DATREUS_TEENSY2
52 OPT_DEFS += -DATREUS_ASTAR
59 # If you don't know the bootloader type, then you can specify the
60 # Boot Section Size in *bytes* by uncommenting out the OPT_DEFS line
62 # Teensy++ halfKay 1024
63 # Atmel DFU loader 4096
64 # LUFA bootloader 4096
66 # OPT_DEFS += -DBOOTLOADER_SIZE=4096
70 # change yes to no to disable
72 BOOTMAGIC_ENABLE = no # Virtual DIP switch configuration(+1000)
73 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
74 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
75 CONSOLE_ENABLE = yes # Console for debug(+400)
76 COMMAND_ENABLE = yes # Commands for debug and configuration
77 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
78 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
79 # if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
80 NKRO_ENABLE = yes # USB Nkey Rollover
81 BACKLIGHT_ENABLE = no # Enable keyboard backlight functionality on B7 by default
82 RGBLIGHT_ENABLE = no # Enable keyboard RGB underglow
83 MIDI_ENABLE = no # MIDI support (+2400 to 4200, depending on config)
84 UNICODE_ENABLE = yes # Unicode
85 BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID
86 AUDIO_ENABLE = no # Audio output on port C6
87 FAUXCLICKY_ENABLE = no # Use buzzer to emulate clicky switches
88 HD44780_ENABLE = no # Enable support for HD44780 based LCDs (+400)