4 OPT_DEFS += -DATREUS_TEENSY2
5 ATRUES_UPLOAD_COMMAND = teensy_loader_cli -w -mmcu=$(MCU) $(TARGET).hex
7 OPT_DEFS += -DATREUS_ASTAR
8 ATRUES_UPLOAD_COMMAND = while [ ! -r $(USB) ]; do sleep 1; done; \
9 avrdude -p $(MCU) -c avr109 -U flash:w:$(TARGET).hex -P $(USB)
16 # Processor frequency.
17 # This will define a symbol, F_CPU, in all source code files equal to the
18 # processor frequency in Hz. You can then use this symbol in your source code to
19 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
20 # automatically to create a 32-bit value in your source code.
22 # This will be an integer division of F_USB below, as it is sourced by
23 # F_USB after it has run through any CPU prescalers. Note that this value
24 # does not *change* the processor frequency - it should merely be updated to
25 # reflect the processor speed set externally so that the code can use accurate
33 # Target architecture (see library "Board Types" documentation).
36 # Input clock frequency.
37 # This will define a symbol, F_USB, in all source code files equal to the
38 # input clock frequency (before any prescaling is performed) in Hz. This value may
39 # differ from F_CPU if prescaling is used on the latter, and is required as the
40 # raw input clock is fed directly to the PLL sections of the AVR for high speed
41 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
42 # at the end, this will be done automatically to create a 32-bit value in your
45 # If no clock division is performed on the input clock inside the AVR (via the
46 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
49 # Interrupt driven control endpoint task(+60)
50 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
53 # Boot Section Size in *bytes*
55 # Teensy++ halfKay 1024
56 # Atmel DFU loader 4096
57 # LUFA bootloader 4096
59 OPT_DEFS += -DBOOTLOADER_SIZE=4096
63 # comment out to disable the options.
65 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
66 MOUSEKEY_ENABLE ?= yes # Mouse keys(+4700)
67 EXTRAKEY_ENABLE ?= yes # Audio control and System control(+450)
68 CONSOLE_ENABLE ?= yes # Console for debug(+400)
69 COMMAND_ENABLE ?= yes # Commands for debug and configuration
70 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
71 # SLEEP_LED_ENABLE ?= yes # Breathing sleep LED during USB suspend
72 NKRO_ENABLE ?= yes # USB Nkey Rollover - not yet supported in LUFA
73 # BACKLIGHT_ENABLE ?= yes # Enable keyboard backlight functionality
74 # MIDI_ENABLE ?= YES # MIDI controls
75 UNICODE_ENABLE ?= YES # Unicode
76 # BLUETOOTH_ENABLE ?= yes # Enable Bluetooth with the Adafruit EZ-Key HID
80 include ../../Makefile
83 USB ?= /dev/cu.usbmodem1411
86 $(ATRUES_UPLOAD_COMMAND)