3 # Target file name (without extension).
5 # project specific files
11 # Processor frequency.
12 # This will define a symbol, F_CPU, in all source code files equal to the
13 # processor frequency in Hz. You can then use this symbol in your source code to
14 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
15 # automatically to create a 32-bit value in your source code.
17 # This will be an integer division of F_USB below, as it is sourced by
18 # F_USB after it has run through any CPU prescalers. Note that this value
19 # does not *change* the processor frequency - it should merely be updated to
20 # reflect the processor speed set externally so that the code can use accurate
28 # Target architecture (see library "Board Types" documentation).
31 # Input clock frequency.
32 # This will define a symbol, F_USB, in all source code files equal to the
33 # input clock frequency (before any prescaling is performed) in Hz. This value may
34 # differ from F_CPU if prescaling is used on the latter, and is required as the
35 # raw input clock is fed directly to the PLL sections of the AVR for high speed
36 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
37 # at the end, this will be done automatically to create a 32-bit value in your
40 # If no clock division is performed on the input clock inside the AVR (via the
41 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
44 # Interrupt driven control endpoint task(+60)
45 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
48 # Boot Section Size in *bytes*
50 # Teensy++ halfKay 1024
51 # Atmel DFU loader 4096
52 # LUFA bootloader 4096
54 OPT_DEFS += -DBOOTLOADER_SIZE=4096
58 # change to no to disable the options.
60 BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
61 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
62 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
63 CONSOLE_ENABLE = yes # Console for debug(+400)
64 COMMAND_ENABLE = yes # Commands for debug and configuration
65 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
66 NKRO_ENABLE = no # USB Nkey Rollover - not yet supported in LUFA