1 #----------------------------------------------------------------------------
4 # make = Make software.
6 # make clean = Clean out built project files.
8 # That's pretty much all you need. To compile, always go make clean,
11 # For advanced users only:
12 # make teensy = Download the hex file to the device, using teensy_loader_cli.
13 # (must have teensy_loader_cli installed).
15 #----------------------------------------------------------------------------
17 # Target file name (without extension).
21 # Directory common source filess exist
23 TMK_DIR = ../../tmk_core
25 # Directory keyboard dependent files exist
28 # # project specific files
34 SRC := keymaps/keymap_$(KEYMAP).c $(SRC)
36 SRC := keymaps/keymap_default.c $(SRC)
45 # Processor frequency.
46 # This will define a symbol, F_CPU, in all source code files equal to the
47 # processor frequency in Hz. You can then use this symbol in your source code to
48 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
49 # automatically to create a 32-bit value in your source code.
51 # This will be an integer division of F_USB below, as it is sourced by
52 # F_USB after it has run through any CPU prescalers. Note that this value
53 # does not *change* the processor frequency - it should merely be updated to
54 # reflect the processor speed set externally so that the code can use accurate
62 # Target architecture (see library "Board Types" documentation).
65 # Input clock frequency.
66 # This will define a symbol, F_USB, in all source code files equal to the
67 # input clock frequency (before any prescaling is performed) in Hz. This value may
68 # differ from F_CPU if prescaling is used on the latter, and is required as the
69 # raw input clock is fed directly to the PLL sections of the AVR for high speed
70 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
71 # at the end, this will be done automatically to create a 32-bit value in your
74 # If no clock division is performed on the input clock inside the AVR (via the
75 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
78 # Interrupt driven control endpoint task(+60)
79 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
82 # Boot Section Size in *bytes*
84 # Teensy++ halfKay 1024
85 # Atmel DFU loader 4096
86 # LUFA bootloader 4096
88 OPT_DEFS += -DBOOTLOADER_SIZE=512
92 # comment out to disable the options.
94 BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
95 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
96 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
97 CONSOLE_ENABLE = yes # Console for debug(+400)
98 COMMAND_ENABLE = yes # Commands for debug and configuration
99 CUSTOM_MATRIX = yes # Custom matrix file for the ErgoDox EZ
100 SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
101 NKRO_ENABLE = yes # USB Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
102 # MIDI_ENABLE = yes # MIDI controls
103 # uNICODE_ENABLE = yes # Unicode
106 # Optimize size but this may cause error "relocation truncated to fit"
107 #EXTRALDFLAGS = -Wl,--relax
110 VPATH += $(TARGET_DIR)
114 include $(TOP_DIR)/quantum/quantum.mk