1 #----------------------------------------------------------------------------
4 # make = Make software.
6 # make clean = Clean out built project files.
8 # That's pretty much all you need. To compile, always go make clean,
11 # For advanced users only:
12 # make teensy = Download the hex file to the device, using teensy_loader_cli.
13 # (must have teensy_loader_cli installed).
15 #----------------------------------------------------------------------------
17 # # project specific files
26 # Processor frequency.
27 # This will define a symbol, F_CPU, in all source code files equal to the
28 # processor frequency in Hz. You can then use this symbol in your source code to
29 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
30 # automatically to create a 32-bit value in your source code.
32 # This will be an integer division of F_USB below, as it is sourced by
33 # F_USB after it has run through any CPU prescalers. Note that this value
34 # does not *change* the processor frequency - it should merely be updated to
35 # reflect the processor speed set externally so that the code can use accurate
42 # Target architecture (see library "Board Types" documentation).
45 # Input clock frequency.
46 # This will define a symbol, F_USB, in all source code files equal to the
47 # input clock frequency (before any prescaling is performed) in Hz. This value may
48 # differ from F_CPU if prescaling is used on the latter, and is required as the
49 # raw input clock is fed directly to the PLL sections of the AVR for high speed
50 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
51 # at the end, this will be done automatically to create a 32-bit value in your
54 # If no clock division is performed on the input clock inside the AVR (via the
55 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
58 # Interrupt driven control endpoint task(+60)
59 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
62 # Boot Section Size in *bytes*
64 # Teensy++ halfKay 1024
65 # Atmel DFU loader 4096
66 # LUFA bootloader 4096
68 OPT_DEFS += -DBOOTLOADER_SIZE=4096
71 # comment out to disable the options.
73 CUSTOM_MATRIX = yes # Custom matrix file for the ErgoDone
74 UNICODE_ENABLE = yes # Unicode
75 BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
76 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
77 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
78 CONSOLE_ENABLE = no # Console for debug(+400)
79 COMMAND_ENABLE = no # Commands for debug and configuration
80 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
81 NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
82 USB_6KRO_ENABLE = no # USB 6key Rollover
83 BACKLIGHT_ENABLE = no # Enable keyboard backlight functionality
84 KEYMAP_IN_EEPROM_ENABLE = no # External keymap in eeprom
85 KEYMAP_SECTION_ENABLE = no # Fixed address keymap for keymap editor
86 SOFTPWM_LED_ENABLE = no # Enable SoftPWM to drive backlight
87 FADING_LED_ENABLE = no # Enable fading backlight
88 BREATHING_LED_ENABLE = no # Enable breathing backlight
89 LEDMAP_ENABLE = no # Enable LED mapping
90 LEDMAP_IN_EEPROM_ENABLE = no # Read LED mapping from eeprom
91 ONEHAND_ENABLE = no # Disable Onehand