One little feature to notice here - these are all absolute file
locations - the line prior to this used relative locations. And
-none of these files exist, either. (Further note - I'm assuming
-all these lines of make I'm following are autogenerated, but
-that'll be something else to discover.)
+none of these files exist, either.
+
+(Further note - I'm assuming all these lines of make I'm following are
+autogenerated, but that'll be something else to discover.)
+
+JM: @emph{``No, these lines are not useful in LilyPond (this is why
+you think they are autogenerated), but they are part of StepMake,
+which was meant to be a package to be installed as a build system over
+autoconf/make in software project source trees.''}
Next in @file{stepmake.make}:
@example
$(outdir)/%.ly: %.lym4
- $(M4) $< | sed "s/\`/,/g" > $@
+ $(M4) $< | sed "s/\`/,/g" > $@@
$(outdir)/%: %.in
- rm -f $@
- cat $< | sed $(sed-atfiles) | sed $(sed-atvariables) > $@
+ rm -f $@@
+ cat $< | sed $(sed-atfiles) | sed $(sed-atvariables) > $@@
@end example
I believe the first rule is for *.ly files, and has a prerequisite
stepmake/stepmake/generic-vars.make has this:
@smallexample
-LOOP=+$(foreach i, $(SUBDIRS), $(MAKE) PACKAGE=$(PACKAGE) package=$(package) -C $(i) $@ &&) true
+LOOP=+$(foreach i, $(SUBDIRS), $(MAKE) PACKAGE=$(PACKAGE) package=$(package) -C $(i) $@@ &&) true
@end smallexample
-$@ is the name of the target - WWW-1 in this case.
+$@@ is the name of the target - WWW-1 in this case.
In GNUmakefile.in we find:
(From the make manual:
-To this end, after reading in all makefiles, make will consider each as a goal target and
-attempt to update it. If a makefile has a rule which says how to update it (found either
-in that very makefile or in another one) or if an implicit rule applies to it (see Chapter 10
-[Using Implicit Rules], page 103), it will be updated if necessary. After all makefiles have
-been checked, if any have actually been changed, make starts with a clean slate and reads
-all the makefiles over again. (It will also attempt to update each of them over again, but
-normally this will not change them again, since they are already up to date.)
+To this end, after reading in all makefiles, make will consider each
+as a goal target and attempt to update it. If a makefile has a rule
+which says how to update it (found either in that very makefile or in
+another one) or if an implicit rule applies to it (see Chapter 10
+[Using Implicit Rules], page 103), it will be updated if
+necessary. After all makefiles have been checked, if any have actually
+been changed, make starts with a clean slate and reads all the
+makefiles over again. (It will also attempt to update each of them
+over again, but normally this will not change them again, since they
+are already up to date.)
So my assumption seems correct)