From: Mark Date: Fri, 24 May 2019 21:18:57 +0000 (+0300) Subject: [Keyboard] Fix formatting on keyboard to micro connection table (#5968) X-Git-Url: https://git.donarmstrong.com/?a=commitdiff_plain;h=4f1537b879366664c94faaef22190c2828115a26;p=qmk_firmware.git [Keyboard] Fix formatting on keyboard to micro connection table (#5968) * Fix formatting on keyboard to micro connection table * Add whitespace to make more readable --- diff --git a/keyboards/converter/palm_usb/readme.md b/keyboards/converter/palm_usb/readme.md index 17ba329da..850005d9e 100644 --- a/keyboards/converter/palm_usb/readme.md +++ b/keyboards/converter/palm_usb/readme.md @@ -23,9 +23,10 @@ qmk because the Arduino softserial library uses different pins from QMK. I've wired the pro micro hardware as follows. -Label| TX0,RX1,GND,GND,2 ,3 ,4 ,5 ,6 ,7 -Palm | , , * ,GND,VCC,RX ,NC ,RTS,nc ,DCD -MCU | ,D1 ,D0 , ,C6 , ,E6 +| Label | TX0 | RX1 | GND | GND | 2 | 3 | 4 | 5 | 6 | 7 | +| --- | --- | --- | --- | --- | --- | --- | --- | --- | --- | --- | +| Palm | | | * | GND | VCC | RX | NC | RTS | NC | DCD | +| MCU | | | | | D1 | D0 | | C6 | | E6 | \* The RX line from the keyboard should be conected to a ~10K ohm pull down resistor to ground. RX --|--3