From: Jack Humbert Date: Tue, 7 Jun 2016 01:54:21 +0000 (-0400) Subject: Update HAND_WIRE.md X-Git-Url: https://git.donarmstrong.com/?a=commitdiff_plain;h=2222621b55768702ab7f0eb9c0276357f8eaa6bc;p=qmk_firmware.git Update HAND_WIRE.md --- diff --git a/doc/HAND_WIRE.md b/doc/HAND_WIRE.md index f5dfc0753..073dbf447 100644 --- a/doc/HAND_WIRE.md +++ b/doc/HAND_WIRE.md @@ -282,7 +282,7 @@ It's also important to use the `KEYMAP` function we defined earlier - this is wh #### Compiling your firmware -After you've written out your entire keymap, you're ready to get the firmware compiled and onto your Teensy. Before compiling, you'll need to get your [development environment set-up](./BUILD_GUIDE.md) - you can skip the dfu-programmer instructions, but you'll need to download and install the [Teensy Loader](https://www.pjrc.com/teensy/loader.html) to get the firmware on your Teensy. +After you've written out your entire keymap, you're ready to get the firmware compiled and onto your Teensy. Before compiling, you'll need to get your [development environment set-up](/doc/BUILD_GUIDE.md) - you can skip the dfu-programmer instructions, but you'll need to download and install the [Teensy Loader](https://www.pjrc.com/teensy/loader.html) to get the firmware on your Teensy. Once everything is installed, running `make` in the terminal should get you some output, and eventually a `.hex` file in that folder. If you're having trouble with this step, see the end of the guide for the trouble-shooting section.