X-Git-Url: https://git.donarmstrong.com/?a=blobdiff_plain;f=keyboards%2Fplanck%2Frules.mk;h=6097902384197bd3c9900d37926bc3e54b4b0899;hb=3cf179be61a10860b2b66aecf2ec5ca6f0e30605;hp=e194dcd5111db80a1d1b596fbd97f4057f6387a2;hpb=ebbc372f72993123cd24fe27228e8d07c9b8d7fb;p=qmk_firmware.git

diff --git a/keyboards/planck/rules.mk b/keyboards/planck/rules.mk
index e194dcd51..609790238 100644
--- a/keyboards/planck/rules.mk
+++ b/keyboards/planck/rules.mk
@@ -1,39 +1,6 @@
 # MCU name
-#MCU = at90usb1287
 MCU = atmega32u4
 
-# Processor frequency.
-#     This will define a symbol, F_CPU, in all source code files equal to the
-#     processor frequency in Hz. You can then use this symbol in your source code to
-#     calculate timings. Do NOT tack on a 'UL' at the end, this will be done
-#     automatically to create a 32-bit value in your source code.
-#
-#     This will be an integer division of F_USB below, as it is sourced by
-#     F_USB after it has run through any CPU prescalers. Note that this value
-#     does not *change* the processor frequency - it should merely be updated to
-#     reflect the processor speed set externally so that the code can use accurate
-#     software delays.
-F_CPU = 16000000
-
-#
-# LUFA specific
-#
-# Target architecture (see library "Board Types" documentation).
-ARCH = AVR8
-
-# Input clock frequency.
-#     This will define a symbol, F_USB, in all source code files equal to the
-#     input clock frequency (before any prescaling is performed) in Hz. This value may
-#     differ from F_CPU if prescaling is used on the latter, and is required as the
-#     raw input clock is fed directly to the PLL sections of the AVR for high speed
-#     clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
-#     at the end, this will be done automatically to create a 32-bit value in your
-#     source code.
-#
-#     If no clock division is performed on the input clock inside the AVR (via the
-#     CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
-F_USB = $(F_CPU)
-
 # Bootloader
 #     This definition is optional, and if your keyboard supports multiple bootloaders of
 #     different sizes, comment this out, and the correct address will be loaded