X-Git-Url: https://git.donarmstrong.com/?a=blobdiff_plain;f=keyboards%2Fhandwired%2Fsplittest%2Frules.mk;h=2aa484db0bb7b4cc10fe43989c6c6b8d48b3da52;hb=0da743d80ba9c8dc913f46f91e16354883ac27ac;hp=9512c0f6482721d50f65cc6288a4815ab0d4ba1b;hpb=188a1e66ff092a1db8adeb5410ba995715ef6594;p=qmk_firmware.git

diff --git a/keyboards/handwired/splittest/rules.mk b/keyboards/handwired/splittest/rules.mk
index 9512c0f64..2aa484db0 100644
--- a/keyboards/handwired/splittest/rules.mk
+++ b/keyboards/handwired/splittest/rules.mk
@@ -1,47 +1,3 @@
-# MCU name
-MCU = atmega32u4
-
-# Processor frequency.
-#     This will define a symbol, F_CPU, in all source code files equal to the
-#     processor frequency in Hz. You can then use this symbol in your source code to
-#     calculate timings. Do NOT tack on a 'UL' at the end, this will be done
-#     automatically to create a 32-bit value in your source code.
-#
-#     This will be an integer division of F_USB below, as it is sourced by
-#     F_USB after it has run through any CPU prescalers. Note that this value
-#     does not *change* the processor frequency - it should merely be updated to
-#     reflect the processor speed set externally so that the code can use accurate
-#     software delays.
-F_CPU = 16000000
-
-#
-# LUFA specific
-#
-# Target architecture (see library "Board Types" documentation).
-ARCH = AVR8
-
-# Input clock frequency.
-#     This will define a symbol, F_USB, in all source code files equal to the
-#     input clock frequency (before any prescaling is performed) in Hz. This value may
-#     differ from F_CPU if prescaling is used on the latter, and is required as the
-#     raw input clock is fed directly to the PLL sections of the AVR for high speed
-#     clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
-#     at the end, this will be done automatically to create a 32-bit value in your
-#     source code.
-#
-#     If no clock division is performed on the input clock inside the AVR (via the
-#     CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
-F_USB = $(F_CPU)
-
-# Bootloader
-#     This definition is optional, and if your keyboard supports multiple bootloaders of
-#     different sizes, comment this out, and the correct address will be loaded
-#     automatically (+60). See bootloader.mk for all options.
-BOOTLOADER = caterina
-
-# Interrupt driven control endpoint task(+60)
-OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
-
 # Build Options
 #   change to "no" to disable the options, or define them in the Makefile in
 #   the appropriate keymap folder that will get included automatically
@@ -63,3 +19,5 @@ RGBLIGHT_ENABLE = yes        # Enable WS2812 RGB underlight.
 SLEEP_LED_ENABLE = no    # Breathing sleep LED during USB suspend
 
 SPLIT_KEYBOARD = yes
+
+DEFAULT_FOLDER = handwired/splittest/promicro