X-Git-Url: https://git.donarmstrong.com/?a=blobdiff_plain;f=Scan%2FUARTConnect%2Fcapabilities.kll;h=bab1b6198ca676e59e3510e1783c99b60c125747;hb=7e68e81f4757ffff2261ab4a887d4114318aa5b6;hp=f02c111e49a4d50e9f992259008704aa3aa4867f;hpb=55d03f448e42ea581810bef3d55eb9c017572665;p=kiibohd-controller.git

diff --git a/Scan/UARTConnect/capabilities.kll b/Scan/UARTConnect/capabilities.kll
index f02c111..bab1b61 100644
--- a/Scan/UARTConnect/capabilities.kll
+++ b/Scan/UARTConnect/capabilities.kll
@@ -26,9 +26,11 @@ UARTConnectBaudFine => UARTConnectBaudFine_define;
 # Thus baud setting = 26
 # NOTE: If finer baud adjustment is needed see UARTx_C4 -> BRFA in the datasheet
 # Baud fine setting = 0x02
-UARTConnectBaud = 1; # 4.5 Mbps @ 72 MHz
+UARTConnectBaud = 1; # 4.5 Mbpsa  @ 72 MHz
 UARTConnectBaudFine = 0x0;
 
+#UARTConnectBaud = 39; # 115385 bps @ 72 MHz (close to 115200)
+
 # Cable Check Command Length
 # This defines the length of the cable command
 # 0xD2 11010010 is used for each check byte
@@ -39,3 +41,8 @@ UARTConnectBaudFine = 0x0;
 UARTConnectCableCheckLength => UARTConnectCableCheckLength_define;
 UARTConnectCableCheckLength = 2;
 
+# Connect Enable
+# Define used to indicate to non-connect modules that support should be compiled in
+ConnectEnabled => ConnectEnabled_define;
+ConnectEnabled = 1;
+