SRC += matrix.c TWIlib.c issi.c lighting.c # MCU name MCU = atmega32u4 # # LUFA specific # # Target architecture (see library "Board Types" documentation). ARCH = AVR8 # Input clock frequency. # This will define a symbol, F_USB, in all source code files equal to the # input clock frequency (before any prescaling is performed) in Hz. This value may # differ from F_CPU if prescaling is used on the latter, and is required as the # raw input clock is fed directly to the PLL sections of the AVR for high speed # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL' # at the end, this will be done automatically to create a 32-bit value in your # source code. # # If no clock division is performed on the input clock inside the AVR (via the # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU. F_USB = $(F_CPU) # Bootloader # This definition is optional, and if your keyboard supports multiple bootloaders of # different sizes, comment this out, and the correct address will be loaded # automatically (+60). See bootloader.mk for all options. BOOTLOADER = caterina # Interrupt driven control endpoint task(+60) OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT # Boot Section Size in *bytes* # Teensy halfKay 512 # Teensy++ halfKay 1024 # Atmel DFU loader 4096 # LUFA bootloader 4096 # USBaspLoader 2048 OPT_DEFS += -DBOOTLOADER_SIZE=4096 # Build Options # change yes to no to disable # BOOTMAGIC_ENABLE = no # Virtual DIP switch configuration(+1000) MOUSEKEY_ENABLE = no # Mouse keys(+4700) EXTRAKEY_ENABLE = yes # Audio control and System control(+450) CONSOLE_ENABLE = no # Console for debug(+400) COMMAND_ENABLE = no # Commands for debug and configuration # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend # if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work NKRO_ENABLE = no # USB Nkey Rollover MIDI_ENABLE = no # MIDI support (+2400 to 4200, depending on config) UNICODE_ENABLE = no # Unicode BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID AUDIO_ENABLE = no # Audio output on port C6 RGBLIGHT_ENABLE = no # Enable WS2812 RGB underlight. FAUXCLICKY_ENABLE = no # Use buzzer to emulate clicky switches BACKLIGHT_CUSTOM_DRIVER = yes BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality, also set ISSI_ENABLE below for Miera ISSI_ENABLE = yes # If the I2C pullup resistors aren't install this must be disabled CUSTOM_MATRIX = yes #ifeq ($(strip $(ISSI_ENABLE)), yes) # TMK_COMMON_DEFS += -DISSI_ENABLE #endif # #ifeq ($(strip $(WATCHDOG_ENABLE)), yes) # TMK_COMMON_DEFS += -DWATCHDOG_ENABLE #endif DEFAULT_FOLDER = meira/promicro LAYOUTS = ortho_4x12