6 # This will define a symbol, F_CPU, in all source code files equal to the
7 # processor frequency in Hz. You can then use this symbol in your source code to
8 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
9 # automatically to create a 32-bit value in your source code.
11 # This will be an integer division of F_USB below, as it is sourced by
12 # F_USB after it has run through any CPU prescalers. Note that this value
13 # does not *change* the processor frequency - it should merely be updated to
14 # reflect the processor speed set externally so that the code can use accurate
19 USB = /dev/cu.usbmodem1421
23 # Target architecture (see library "Board Types" documentation).
26 # Input clock frequency.
27 # This will define a symbol, F_USB, in all source code files equal to the
28 # input clock frequency (before any prescaling is performed) in Hz. This value may
29 # differ from F_CPU if prescaling is used on the latter, and is required as the
30 # raw input clock is fed directly to the PLL sections of the AVR for high speed
31 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
32 # at the end, this will be done automatically to create a 32-bit value in your
35 # If no clock division is performed on the input clock inside the AVR (via the
36 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
40 # This definition is optional, and if your keyboard supports multiple bootloaders of
41 # different sizes, comment this out, and the correct address will be loaded
42 # automatically (+60). See bootloader.mk for all options.
45 OPT_DEFS += -DATREUS_TEENSY2
46 ATREUS_UPLOAD_COMMAND = teensy_loader_cli -w -mmcu=$(MCU) $(TARGET).hex
49 OPT_DEFS += -DATREUS_ASTAR
50 ATREUS_UPLOAD_COMMAND = while [ ! -r $(USB) ]; do sleep 1; done; \
51 avrdude -p $(MCU) -c avr109 -U flash:w:$(TARGET).hex -P $(USB)
54 # Interrupt driven control endpoint task(+60)
55 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
60 # change yes to no to disable
62 BOOTMAGIC_ENABLE = no # Virtual DIP switch configuration(+1000)
63 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
64 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
65 CONSOLE_ENABLE = no # Console for debug(+400)
66 COMMAND_ENABLE = no # Commands for debug and configuration
67 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
68 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
69 # if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
70 NKRO_ENABLE = no # USB Nkey Rollover
71 BACKLIGHT_ENABLE = no # Enable keyboard backlight functionality on B7 by default
72 MIDI_ENABLE = no # MIDI controls
73 UNICODE_ENABLE = no # Unicode
74 BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID
75 AUDIO_ENABLE = no # Audio output on port C6
78 # $(ATREUS_UPLOAD_COMMAND)