4 OPT_DEFS += -DATREUS_TEENSY2
5 ATREUS_UPLOAD_COMMAND = teensy_loader_cli -w -mmcu=$(MCU) $(TARGET).hex
7 OPT_DEFS += -DATREUS_ASTAR
11 ATREUS_UPLOAD_COMMAND = while [ ! -r $(USB) ]; do sleep 1; done; \
12 avrdude -p $(MCU) -c avr109 -U flash:w:$(TARGET).hex -P $(USB)
19 # Processor frequency.
20 # This will define a symbol, F_CPU, in all source code files equal to the
21 # processor frequency in Hz. You can then use this symbol in your source code to
22 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
23 # automatically to create a 32-bit value in your source code.
25 # This will be an integer division of F_USB below, as it is sourced by
26 # F_USB after it has run through any CPU prescalers. Note that this value
27 # does not *change* the processor frequency - it should merely be updated to
28 # reflect the processor speed set externally so that the code can use accurate
35 # Target architecture (see library "Board Types" documentation).
38 # Input clock frequency.
39 # This will define a symbol, F_USB, in all source code files equal to the
40 # input clock frequency (before any prescaling is performed) in Hz. This value may
41 # differ from F_CPU if prescaling is used on the latter, and is required as the
42 # raw input clock is fed directly to the PLL sections of the AVR for high speed
43 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
44 # at the end, this will be done automatically to create a 32-bit value in your
47 # If no clock division is performed on the input clock inside the AVR (via the
48 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
52 # This definition is optional, and if your keyboard supports multiple bootloaders of
53 # different sizes, comment this out, and the correct address will be loaded
54 # automatically (+60). See bootloader.mk for all options.
61 # Interrupt driven control endpoint task(+60)
62 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
66 # comment out to disable the options.
68 #BOOTMAGIC_ENABLE = yes # Virtual DIP switch configuration(+1000)
69 MOUSEKEY_ENABLE = yes # Mouse keys(+4700)
70 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
71 CONSOLE_ENABLE = yes # Console for debug(+400)
72 COMMAND_ENABLE = yes # Commands for debug and configuration
73 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
74 # SLEEP_LED_ENABLE = yes # Breathing sleep LED during USB suspend
75 NKRO_ENABLE = yes # USB Nkey Rollover - not yet supported in LUFA
76 # BACKLIGHT_ENABLE = yes # Enable keyboard backlight functionality
77 # MIDI_ENABLE = YES # MIDI controls
78 UNICODE_ENABLE = YES # Unicode
79 # BLUETOOTH_ENABLE = yes # Enable Bluetooth with the Adafruit EZ-Key HID
81 USB = /dev/cu.usbmodem1411