3 # # project specific files
10 # Processor frequency.
11 # This will define a symbol, F_CPU, in all source code files equal to the
12 # processor frequency in Hz. You can then use this symbol in your source code to
13 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
14 # automatically to create a 32-bit value in your source code.
16 # This will be an integer division of F_USB below, as it is sourced by
17 # F_USB after it has run through any CPU prescalers. Note that this value
18 # does not *change* the processor frequency - it should merely be updated to
19 # reflect the processor speed set externally so that the code can use accurate
27 # Target architecture (see library "Board Types" documentation).
30 # Input clock frequency.
31 # This will define a symbol, F_USB, in all source code files equal to the
32 # input clock frequency (before any prescaling is performed) in Hz. This value may
33 # differ from F_CPU if prescaling is used on the latter, and is required as the
34 # raw input clock is fed directly to the PLL sections of the AVR for high speed
35 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
36 # at the end, this will be done automatically to create a 32-bit value in your
39 # If no clock division is performed on the input clock inside the AVR (via the
40 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
43 # Interrupt driven control endpoint task(+60)
44 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
47 # Boot Section Size in *bytes*
49 # Teensy++ halfKay 1024
50 # Atmel DFU loader 4096
51 # LUFA bootloader 4096
53 OPT_DEFS += -DBOOTLOADER_SIZE=4096
57 # comment out to disable the options.
59 BOOTMAGIC_ENABLE ?= yes # Virtual DIP switch configuration(+1000)
60 # MOUSEKEY_ENABLE ?= yes # Mouse keys(+4700)
61 # EXTRAKEY_ENABLE ?= yes # Audio control and System control(+450)
62 # CONSOLE_ENABLE ?= yes # Console for debug(+400)
63 # COMMAND_ENABLE ?= yes # Commands for debug and configuration
64 NKRO_ENABLE ?= yes # USB Nkey Rollover - if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
65 BACKLIGHT_ENABLE ?= yes # Enable numpad's backlight functionality
66 RGBLIGHT_ENABLE ?= yes
67 # MIDI_ENABLE ?= YES # MIDI controls
68 # UNICODE_ENABLE ?= YES # Unicode
69 # BLUETOOTH_ENABLE ?= yes # Enable Bluetooth with the Adafruit EZ-Key HID
73 include ../../Makefile