1 # project specific files
2 SRC = keyboards/wilba_tech/wt_main.c \
3 keyboards/wilba_tech/wt_rgb_backlight.c \
5 drivers/issi/is31fl3731.c \
6 drivers/avr/i2c_master.c
11 # Processor frequency.
12 # This will define a symbol, F_CPU, in all source code files equal to the
13 # processor frequency in Hz. You can then use this symbol in your source code to
14 # calculate timings. Do NOT tack on a 'UL' at the end, this will be done
15 # automatically to create a 32-bit value in your source code.
17 # This will be an integer division of F_USB below, as it is sourced by
18 # F_USB after it has run through any CPU prescalers. Note that this value
19 # does not *change* the processor frequency - it should merely be updated to
20 # reflect the processor speed set externally so that the code can use accurate
28 # Target architecture (see library "Board Types" documentation).
31 # Input clock frequency.
32 # This will define a symbol, F_USB, in all source code files equal to the
33 # input clock frequency (before any prescaling is performed) in Hz. This value may
34 # differ from F_CPU if prescaling is used on the latter, and is required as the
35 # raw input clock is fed directly to the PLL sections of the AVR for high speed
36 # clock generation for the USB and other AVR subsections. Do NOT tack on a 'UL'
37 # at the end, this will be done automatically to create a 32-bit value in your
40 # If no clock division is performed on the input clock inside the AVR (via the
41 # CPU clock adjust registers or the clock division fuses), this will be equal to F_CPU.
44 # Interrupt driven control endpoint task(+60)
45 OPT_DEFS += -DINTERRUPT_CONTROL_ENDPOINT
49 BOOTLOADER = atmel-dfu
53 # change yes to no to disable
55 BOOTMAGIC_ENABLE = no # Virtual DIP switch configuration(+1000)
56 MOUSEKEY_ENABLE = no # Mouse keys(+4700)
57 EXTRAKEY_ENABLE = yes # Audio control and System control(+450)
58 CONSOLE_ENABLE = no # Console for debug(+400)
59 COMMAND_ENABLE = no # Commands for debug and configuration
60 # Do not enable SLEEP_LED_ENABLE. it uses the same timer as BACKLIGHT_ENABLE
61 SLEEP_LED_ENABLE = no # Breathing sleep LED during USB suspend
62 # if this doesn't work, see here: https://github.com/tmk/tmk_keyboard/wiki/FAQ#nkro-doesnt-work
63 NKRO_ENABLE = yes # USB Nkey Rollover
64 BACKLIGHT_ENABLE = no # Enable keyboard backlight functionality on B7 by default
65 MIDI_ENABLE = no # MIDI support (+2400 to 4200, depending on config)
66 UNICODE_ENABLE = no # Unicode
67 BLUETOOTH_ENABLE = no # Enable Bluetooth with the Adafruit EZ-Key HID
68 AUDIO_ENABLE = no # Audio output on port C6
69 FAUXCLICKY_ENABLE = no # Use buzzer to emulate clicky switches
72 DYNAMIC_KEYMAP_ENABLE = yes